Insignia NS-20EM50A13 User Manual (English) - Page 8
Legal notices - led monitor
View all Insignia NS-20EM50A13 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
Supported Timing Modes VGA 720 x 400 @ 70 Hz VGA 640 x 480 @ 60 Hz MAC 640 x 480 @ 67 Hz VESA 640 x 480 @ 72 Hz VESA 640 x 480 @ 75 Hz VESA 800 x 600 @ 56 Hz VESA 800 x 600 @ 60 Hz VESA 800 x 600 @ 72 Hz VESA 800 x 600 @ 75 Hz MAC 832 x 624 @ 75 Hz VESA 1024 x 768 @ 60 Hz VESA 1024 x 768 @ 70 Hz VESA 1024 x 768 @ 75 Hz VESA 1152 x 864 @ 75 Hz MAC 1152 x 870 @ 75 Hz VESA 1280 x 720 @ 60 Hz VESA 1280 x 960 @ 60 Hz VESA 1280 x 1024 @ 60 Hz VESA 1280 x 1024 @ 75 Hz VESA 1440 x 900 @ 60 Hz VESA 1440 x 900 @ 75 Hz VESA 1600 x 900 @ 60 Hz Caution Do not set the graphic card in your computer to exceed these maximum refresh rates. Doing so may result in permanent damage to your monitor. Legal notices FCC Part 15 This device complies with Part 15 of the FCC Rules. Operation of this product is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply within the limits for a class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: • Reorient or relocate the receiving antenna. • Increase the separation between the equipment and receiver. • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. • Consult the dealer or an experienced technician for help. FCC warning Changes or modifications not expressly approved by the party responsible for compliance with the FCC Rules could void the user's authority to operate this equipment. Note If necessary, shielded interface cables and AC power cord must be used to meet the emission level limits. NS-20EM50A13 20" Widescreen LED Monitor 6 www.insigniaproducts.com