Insignia NS-24E340A13 User Manual (English) - Page 16
Connecting an antenna or cable TV no box, Connecting a DVD or Blu-ray player
View all Insignia NS-24E340A13 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 16 highlights
NS-24E340A13 Insignia 24" 1080p LED TV Connecting an antenna or cable TV (no box) To connect an antenna or cable TV (no box): 1 Make sure that your TV's power cord is unplugged, and all connected equipment is turned off. 2 Connect a coaxial cable (not provided) to the ANT/CABLE jack on the back of your TV and to the antenna or cable TV wall jack. Antenna or cable TV (no box) Connecting a DVD or Blu-ray player Using HDMI (best) To connect a DVD or Blu-ray player using HDMI: 1 Make sure that your TV's power cord is unplugged and the DVD or Blu-ray player is turned off. 2 Connect an HDMI cable (not provided) to one of the HDMI jacks on the side of your TV and to the HDMI OUT jack on the DVD or Blu-ray player. DVD or Blu-ray player USB HDMI cable Back of TV Coaxial cable 3 Plug your TV's power cord into a power outlet, then turn on your TV. 4 Go through the Setup Wizard on page 19. Notes • • • Use a coaxial cable to eliminate interference and noise from radio waves. Do not bundle the coaxial cable with the power cord or other cables. If the antenna is not installed correctly, contact qualified service personnel to correct the problem. If the signal level for a channel is weak, the picture may be distorted. Adjust the antenna or use a highly directional outdoor or set-top antenna with a built-in amplifier. If the picture quality is good on some channels and poor on others, the problem may be caused by a poor or weak signal from the broadcaster or cable TV provider. If you connect to cable or satellite TV without a set-top box and experience poor picture quality, you may need to install a set-top box to improve signal reception and picture quality. Contact your cable or satellite TV provider about upgrading to a set-top box. Many high-definition (HD) channels upscale standard-definition (SD) content. The picture displayed on your TV is still displayed as SD, thus the picture quality will not be as clear or crisp as it would be if the content was originally recorded in HD. Side of TV 3 Plug your TV's power cord into a power outlet, then turn on your TV. 4 Turn on the DVD or Blu-ray player, then set it to the correct output mode. For more information, see the documentation that came with the player. 5 Press INPUT to open the Input Source list. 6 Press S or T to highlight HDMI 1 or HDMI 2, then press ENTER. Note You can also press HDMI repeatedly to select the DVD or Blu-ray player. 12 www.insigniaproducts.com