Insignia NS-BCDCAS1 Quick Setup Guide (English) - Page 2

Setting up your boombox Connecting the AC power adapter 1 Make sure that your local AC power source matches the voltage shown on the plate located on the AC power adapter. If it does not, consult your dealer or service center. 2 Insert the small connector at the end of the AC power adapter cable into the DC IN jack on the back of your boombox. 3 Plug the AC power adapter into a wall power outlet. Installing the batteries (optional - for portable use) 1 Turn your boombox over, then open and remove the door to the battery compartment. 2 Insert six (6) "D" size batteries into the battery compartment. Make sure that you match the + and - symbols on the batteries with the + and - symbols in the battery compartment. 3 Reinstall and close the battery compartment door and return your boombox to the upright position. Connecting headphones • Plug your headphones (not included) into the headphone jack on the back of the unit. Caution: Listening to high volume sound for long periods of time can damage your hearing. Using your boombox Playing the radio 1 Press (Standby/ON) to turn on the boombox. 2 Press (source) repeatedly to select RADIO mode, then press BAND to select AM or FM. 3 Press (next) or (previous) to tune the radio to a higher or lower frequency. Press and hold (next) or (previous) for two seconds to automatically tune to the next or previous station. 4 Adjust the volume to a comfortable level by pressing either the VOLUME + or VOLUME - button. 5 Press (Standby/ON) to turn off the boombox. Using presets 1 Press (Standby/ON) to turn on the boombox. 2 Press (source) repeatedly to select RADIO mode, then press BAND to select AM or FM. 3 Press (next) or (previous) to tune the radio to a higher or lower frequency. Press and hold (next) or (previous) for two seconds to automatically tune to the next or previous station. 4 To save the station as a preset, press and hold the MEM button. "MEMORY" blinks on the display. 5 Press (next) or (previous) to select the preset number you want. 6 Press the MEM button again to confirm and store the preset. 7 Repeat Steps 3 to 6 to store as many as 10 AM presets and 10 FM presets. 8 To select a preset station, press MEM repeatedly until you reach the station you want. Playing CDs 1 Press (Standby/ON) to turn on the boombox. 2 Press (source) repeatedly to select CD mode. 3 Press the PRESS TO OPEN area on the CD door to open the lid. 4 Insert a CD, label side up. 5 Press the PRESS TO OPEN area on the CD door to close it. Playback begins automatically and stops when finished. 6 Press (stop) to stop the CD before it is finished. The total number of tracks appears on the display. Playing cassette tapes 1 Press (Standby/ON) to turn on the boombox. 2 Press (source) repeatedly to select TAPE mode. "CAS" appears on the display. 3 Press STOP/ EJECT to open the cassette door. 4 Insert a cassette tape into the door, then gently push the door closed. 5 Press REW or FWD to wind the cassette tape to the starting point you want, then press STOP/ EJECT to stop the cassette tape. 6 Press PLAY to begin playback. 7 Press PAUSE to pause playback. Press PAUSE again to resume playback. 8 Press STOP/ EJECT to stop playback. For information on recording cassette tapes, see your User Guide. Listening to an external audio device 1 Make sure the boombox is turned off. 2 Plug one end of the 3.5 mm AUX cable (not included) into the AUX IN jack on the back of your boombox. 3 Plug the other end of the cord into the Line-out jack on the audio device such as an iPod or other MP3 player. 4 Press (Standby/ON) to turn on the boombox. 5 Press (source) one or more times until "Aud" appears on the display. 6 Use the controls on the audio device to control playback. Troubleshooting Problem: Solution: Your boombox will not turn on • Unplug your boombox for a few moments, then plug it back in. • Make sure that the AC outlet is working by plugging another device into it. CD player will not play • Make sure that you have put a CD in the CD tray. • Make sure the CD is inserted label side up. • Try a different CD. • Make sure that the CD player is not paused. • Make sure that the CD mode is selected. • Make sure you are using a compatible CD. Your boombox can play standard and 3" audio CDs, CD-R, and CD-RW. A CD skips while playing • Wipe the CD with a cloth to clean it. • Try a different CD. • Make sure that the CD is not warped, scratched, or damaged. • Make sure that your boombox is not being affected by vibration or shock. Move the boombox if necessary. • Make sure you are using a compatible CD. Your boombox can play standard and 3" audio CDs, CD-R, and CD-RW. Noise or sound distorted on AM or FM radio broadcasts • Extend the FM antenna. • Rotate your boombox until the best reception is obtained. • Try turning off electrical appliances near your boombox, such as hair dryers, vacuum cleaners, or fluorescent lights. No sound • Increase the volume. • Plug in the AC power adapter and press (Standby/ON) to turn on your boombox. • Make sure that you have installed fresh batteries and that they are installed correctly. • Make sure that you have selected the correct source. • If you are in AUX mode, make sure the volume has not been muted on your playback device. Low volume • If you are using AUX mode, make sure the volume is turned up on both your audio source and your boombox. A cassette tape will not play/record • Open the cassette door and make sure the tape has not been tangled in the tape drive mechanism. • Rewind your tape or turn it over to the other side. FCC Statement This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. FCC Caution Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, maybe cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: • Reorient or relocate the receiving antenna. • Increase the separation between the equipment and receiver. • Connect the equipment into an outlet on a circuit different form that to which the receiver is connected. • Consult the dealer or an experienced radio/TV technician for help. CAN ICES-3 (B)/NMB-3 (B) This product complies with DHHS Rules 21 CFR Sub-chapter J. Applicable at the date of manufacture. 90-day limited warranty. Visit www.insigniaproducts.com for details. For customer support, call 1-877-467-4289 (U.S. and Canada) or 01-800-926-3000 (Mexico). We're here for you at www.insigniaproducts.com. INSIGNIA is a registered trademark of BBY Solutions, Inc. Registered in some countries. Distributed by Best Buy Purchasing, LLC, 7601 Penn Ave South, Richfield, MN 55423 U.S.A. ©2013 BBY Solutions, Inc. All Rights Reserved. V1 ENGLISH 13-0710