Insignia NS-BIPCD02 User Manual (English) - Page 9
Setting up your boombox
View all Insignia NS-BIPCD02 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
NS-BIPCD02 Boombox with iPod/iPhone dock and CD Setting up your boombox Powering your boombox Your boombox can be powered by either the included AC Adapter, or by using eight "C" sized alkaline batteries. Your boombox only operates on batteries if the AC adapter is unplugged. Installing the batteries To install the batteries: 1 Open the battery compartment on the bottom of your boombox. 2 Place eight "C" size alkaline batteries (not included) into the battery compartment. Make sure to match the + and - on the battery to the + and - signs in the battery compartment. 3 Close the battery compartment until it clicks into place. Caution • When you replace the batteries, make sure that you use batteries of the same type and voltage. The batteries are "C" size alkaline. • All batteries should be replaced at the same time. • Dispose of used batteries by following your local hazardous waste regulations. • If you don't plan to use your boombox for an extended period of time, remove the batteries to prevent damage. Note BATT LOW will be shown on the display when the batteries are lower than 20% capacity. Connecting the AC adapter To connect the AC adapter: 1 Plug the small connector at the end of the power cord into the DC IN jack on the back of your boombox. 2 Plug the AC adapter into a 120/240V, 50/60Hz power outlet. www.insigniaproducts.com 9