Insignia NS-CF43SS6 Quick Setup Guide - Page 2

Resetting your filter indicator Note: These are the most common filter reset instructions. If the instructions don't work for your refrigerator brand, see the documentation that came with your refrigerator. REFRIGERATOR BRAND Amana GE or Hotpoint Samsung LG Kenmore INSTRUCTIONS Press and hold the dispenser lock and auto light buttons at the same time. When the filter indicator flashes (about four seconds), release both buttons. OR Press and hold the dispenser lock and water buttons at the same time. When the filter indicator flashes (about four seconds), release both buttons. Press and hold the reset water filter button on the dispenser for three seconds. Press and hold the ice type and child lock buttons for three seconds. The water filter indicator should turn green. Note: Only hold these buttons for three seconds. Holding these buttons for five seconds cancels the reset. If you cancel the reset, repeat the instructions above again. Press and hold the reset button for three seconds. The water filter reset for Kenmore refrigerators varies by model. See the documentation that came with your refrigerator. Troubleshooting PROBLEM My refrigerator is not dispensing water SOLUTION • Make sure that you soaked your filter in water for 15 minutes before installing. • Make sure that the filter is securely connected to the receiver. Do not use tools to tighten the filter in place. • Make sure that the water line to the refrigerator is turned on. The valve must be completely open for the refrigerator to receive water. • Make sure that the refrigerator door is closed or the dispenser will not work. My water dispenser is dripping • A few drops are normal. If the water is dripping constantly, have a service technician check your refrigerator's water valve. My water is cloudy • Cloudy water is caused by microscopic air bubbles. Run two to three or contains black gallons of water from your dispenser to clear the air bubbles out. carbon pieces • Black carbon pieces in the water are normal and appear with all carbon filters. Run two to three gallons of water through your dispenser to remove loose carbon pieces. My new filter is making noises or sputtering • Make sure that you soaked your filter in water for 15 minutes before installing. • Noises and sputtering are caused by trapped air pockets. Run two to three gallons of water from your dispenser to push the air out. My water tastes bad • If you do not use your water dispenser for more than four days, run two gallons of water through the dispenser before using it. • Make sure that you replace your filter every three to six months to prevent bacteria growth. Recycling your used Insignia filter Help the environment by recycling your used Insignia filter at your local recycling facility or mail it to: Insignia Filters 2678 Ram Bay Road Manning, South Carolina 29102 6-month limited warranty For complete warranty, visit www.insigniaproducts.com. Contact Insignia 1-877-467-4289 (U.S. and Canada) or 01-800-926-3000 (Mexico) www.insigniaproducts.com CERTIFICATIONS: INSIGNIA is a registered trademark of BBY Solutions, Inc. Registered in some countries. Distributed by Best Buy Purchasing, LLC, 7601 Penn Ave South, Richfield, MN 55423 U.S.A. ©2014 BBY Solutions, Inc. All Rights Reserved. Storage and maintenance • Replace your filter every three to six months to prevent bacteria and fungus growth in your filter, supply lines, and storage tank. • Stored filters do not expire. Keep your unused filters in a cool, dark, and dry place until you need them. • If you do not use your water dispenser for more than four days, run two gallons of water before using it to prevent bad tasting water. • The filters are lubricated with a safe, USDA grade silicone. You do not need to lubricate the gaskets or receiver before installing. V2 ENGLISH 14-0651