Insignia NS-DWH1WH9 Installation Guide - Page 19
Step 12: Connecting the water supply line, Step 13: Connecting the drain hose, IMPORTANT
View all Insignia NS-DWH1WH9 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 19 highlights
NS-DWH2BS8 / NS-DWH2SS8 / NS-DWR2BS8 / NS-DWR2WH8 Step 12: Connecting the water supply line 1 Make sure that you wrapped the 90° elbow with Teflon thread seal tape twice. 2 Slide the compression nut, then the ferrule over the end of the water supply line. Note: If you have a steel-grated line, you do not need a ferrule or compression nut. 3 Insert the water supply line into the 90° elbow. 4 Slide the ferrule against the 90° elbow and secure it with the compression nut. Back of dishwasher Two wraps of Teflon thread seal tape Ferrule 90° elbow Water supply line Compression nut IMPORTANT: Make sure that the door spring does not rub or contact the water supply line or drain hose. Test by opening and closing the door. Reroute the lines if interference occurs. You'll need: Adjustable wrench Hot water line kit Teflon thread seal tape Step 13: Connecting the drain hose IMPORTANT: Follow all local codes and ordinances. 1 Cut on the marked line as required for your installation. The drain hose's molded end will fit 5/8", 3/4" or 1" diameter connections on the air gap, waste tee, or garbage disposal. Cutting lines IMPORTANT: Do not cut corrugated portion of hose www.insigniaproducts.com 19