Insignia NS-L47Q09-10A User Manual (English) - Page 13

Insignia 47" LCD TV Connecting an indoor antenna To connect an indoor antenna: 1 Turn off your TV and all connected equipment. 2 Connect the included dual-telescoping dipole antenna to the ANTENNA/CABLE DIGITAL/ANALOG jack on the back of your TV. Note Distance from the transmitting source, a man-made shelter, or natural atmospheric conditions might influence the reception, which is not related to antenna performance. Connecting cable TV Your TV has a 75 ohm jack for connecting cable TV. Some cable TV providers scramble the signals for "premium" (pay) channels. To view these channels, you need a converter/descrambler box. If you do not require a converter/descrambler box, you can connect your cable TV directly to your TV. For more information, see "No converter/descrambler box" on page 9. If you require a converter/descrambler box, you can connect your cable TV using an RF switch (not included). For more information about connecting a converter/descrambler box, see "With converter/descrambler box" on page 9 and contact your cable TV provider. You can also connect cable TV using an HDMI, component video, S-Video, or AV connection, depending on your cable box. For more information, see "Connecting cable TV via a cable TV box" on page 9. No converter/descrambler box To connect cable TV without a converter/descrambler box: 1 Connect one end of a 75 ohm cable to the coaxial jack on the back of your TV. With converter/descrambler box If your cable box descrambles only some channels (such as premium channels), you need a two-way splitter, an RF (A/B) switch, and four lengths of antenna cable. The two-way splitter and RF switch are not provided. To connect cable TV with a converter/descrambler box: • Use the following illustration as a guide to connect a converter/descrambler box. Set the RF switch to the A position to tune to unscrambled channels using your TV remote control. Set the RF switch to the B position to watch scrambled channels using the converter/descrambler controls. RF switch A Two-set signal splitter B Out In TV Cable converter/descrambler box Connecting cable TV via a cable TV box 1 Connect the incoming cable from the cable wall jack to the cable-in jack on the cable box. 2 Depending on the jacks available on the cable box, connect a cable from the outgoing jacks on the cable box to the corresponding jacks on the back of your TV. The connection can be to the cable-out, HDMI, component video, S-Video, or AV jack. Back of TV Cable box IANNTENONUAT HDMI Video or S-Video Component 3 If you use a component video, S-Video, or AV cable, connect an audio cable to the corresponding jacks on the back of your TV and on the cable box. 2 Connect the other end of the cable to the cable TV wall outlet. www.insigniaproducts.com 9