Insignia NS-SB212 Template (English) - Page 1
Insignia NS-SB212 Manual
View all Insignia NS-SB212 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1 highlights
88 mm Hold this template to the wall and use a level to level it, then temporarily tape it to the wall. Wall Drill two holes at the indicated points. Drill a hole here LEVELING EDGE Wall Anchor Remove the template from the wall. You must use suitable wall anchors (not supplied) if you are mounting on drywall, concrete, or other wall types. Wall 6 to 8 mm (1/4 inches) Fasten two screws (not supplied) to the wall. The screw heads should protrude from the wall approximately 1/4 in. (6-8 mm). The screw width must be about 3/16" and the screw head about 1/4" to 3/8". Soundbar Wall Align the speaker hanging brackets with the screws, then hang the soundbar on the screws. 799 mm 406.4 mm Hold a level to the Leveling Edge of this template LEVELING EDGE Wall mount template Locate / Position holes onto studs behind drywall or use anchors for mounting Warning: Improper installation can result in serious injury or damage to your soundbar. If necessary, seek the assistance of a professional. Drill a hole here 12-0293