Insignia NS-TVMFP12 User Manual (English) - Page 10
Option 1: Installing on a wood stud wall, STEP 5
![]() |
View all Insignia NS-TVMFP12 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
10 STEP 5 - Option 1: Installing on a wood stud wall* Note: Any drywall covering the wall must not exceed 5/8 in. (16 mm). 1 Locate the stud. Verify the center of the stud with an edge-to-edge stud finder. 2 Align the wall plate template (P) at the height you determined in the previous step (or by using the HeightFinder mentioned on the template), make sure that it is level, then tape it to the wall. 3 Drill pilot holes through the template to a depth of 3 in. (75 mm) using a 7/32 in. (5.5 mm) diameter drill bit, then remove the template. 4 Align the wall plate (A) with the pilot holes, insert the lag bolts (S) through the lag bolt washers (R), then through the holes in the wall plate. Tighten the lag bolts only until they are firm against the wall plate. CAUTION: Avoid potential injuries or property damage! DO NOT over-tighten the lag bolts (S). * Minimum wood stud size: common 2 x 4 in. (51 x 102 mm) nominal 11/2 x 31/2 in. (38 x 89 mm). You'll need A SR 3 in. (75 mm) Wall plate (A) Edge-to edge stud finder Drill S (2) Wall plate template (P) R (2) 7/32 in. wood drill bit 1/2 in. socket wrench Level Tape
![](/manual_guide/products/insignia-nstvmfp12-user-manual-english-c9ad0b8/10.png)