Intel BLKD865GSAL Product Specification - Page 43
Hardware Support
View all Intel BLKD865GSAL manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 43 highlights
Product Description 1.10.1.2 Wake-up Devices and Events Table 14 lists the devices or specific events that can wake the computer from specific states. Table 14. Wake-up Devices and Events These devices/events can wake up the computer... LAN ...from this state S1, S3, S4, S5 (Note) Modem (back panel Serial Port A) PME# signal Power switch PS/2 devices RTC alarm S1, S3 S1, S3, S4, S5 (Note) S1, S3, S4, S5 S1, S3 S1, S3, S4, S5 USB S1, S3 Note: For LAN and PME# signal, S5 is disabled by default in the BIOS Setup program. Setting this option to Power On will enable a wake-up event from LAN in the S5 state. NOTE The use of these wake-up events from an ACPI state requires an operating system that provides full ACPI support. In addition, software, drivers, and peripherals must fully support ACPI wake events. 1.10.2 Hardware Support CAUTION Ensure that the power supply provides adequate +5 V standby current if LAN wake capabilities and Instantly Available PC technology features are used. Failure to do so can damage the power supply. The total amount of standby current required depends on the wake devices supported and manufacturing options. The board provides several power management hardware features, including: • Power connector • Fan connectors • LAN wake capabilities • Instantly Available PC technology • Resume on Ring • Wake from USB • Wake from PS/2 keyboard • PME# signal wake-up support LAN wake capabilities and Instantly Available PC technology require power from the +5 V standby line. The sections discussing these features describe the incremental standby power requirements for each. 43