Intel D955XBK English Product Guide - Page 39
Connecting the IDE Cable
View all Intel D955XBK manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 39 highlights
Installing and Replacing Desktop Board Components Connecting the IDE Cable The IDE cable can connect two drives to the desktop board. The cable supports the ATA-66/100 transfer protocol. Figure 20 shows the correct installation of the cable. NOTE ATA-66/100 compatible cables are backward compatible with drives using slower IDE transfer protocols. If an ATA-66/100 disk drive and a disk drive using any other IDE transfer protocol are attached to the same cable, the maximum transfer rate between the drives may be reduced to that of the slowest drive. NOTE Do not connect an ATA device as a slave on the same IDE cable as an ATAPI master device. For example, do not connect an ATA hard drive as a slave to an ATAPI CD-ROM drive. For correct function of the cable: 1. Observe the precautions in "Before You Begin" on page 23. 2. Attach the cable end with the single connector to the desktop board (Figure 20, A). 3. Attach the cable end with the two closely spaced connectors to the drives (Figure 20, B). A Figure 20. Connecting the IDE Cable B OM17598 39