Intel RS2BL080 Hardware User Guide - Page 24
Technical Specifications - compatibility
UPC - 735858210140
View all Intel RS2BL080 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 24 highlights
Jumper Description JT12 Individual Drive Fault LED header Type 8 x 2 header JT13 Universal Asynchronous 4-pin connector Receiver/Transmitter (UART) Comments Indicates drive faults. There is one LED per port. When lit, each LED indicates the corresponding drive has failed or is in the Unconfigured-Bad state. The LEDs function in a direct-attach configuration (there are no SAS expanders). Direct attach is defined as a maximum of one drive connected directly to each port. Note: This header is used for RAID controllers with internal SAS ports only. For factory and debug use Technical Specifications Table 2. Technical Specifications Specification RAID-on-Chip (ROC ) Operating voltage Card size Array interface to host SAS/SATA bus speed SAS/SATA ports Physical and virtual drive support Cache Firmware Compatible devices Cabling Redundant configuration Enclosure management Enclosure support Intel® RAID Controller RS2BL080 LSISAS2108 Integrated ROC, 800 MHz +3.3 V, +12 V Low profile, extended half-length (6.6-inch, MD2) PCI Express* Revision 2.0, x8 lane width 5.0 Gbps Up to 6 Gbps per port, point-to-point 2x4 internal ports, 32 devices per port with expanders 32 physical drives, 64 virtual drives, and 16 RAID arrays per controller 512 MB DDR2 800 MHz SDRAM, optional battery backup 8 MB in reflashable flash ROM • 2.5-inch and 3.5-inch SAS or SATA II drives • Non disk devices including expanders • Can support drives of mixed capacity • Small, thin cables that do not restrict airflow • Shared connectors for multiple drives 32 KB NVRAM and config-on-disk (COD) • SGPIO • In-band and out-of-band SES Assumes one SEP per enclosure 14 Intel® RAID Controller RS2BL080 Hardware User's Guide