Intel RS2WC080 Hardware User Guide - Page 24
Technical Specifications - it mode
View all Intel RS2WC080 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 24 highlights
Jumper Type TP1 4-pin connector U1 2-pin connector Description Universal Asynchronous Receiver/Transmitter (UART) Reserved for factory use RAID Premium Feature Key header. Enables support for RAID premium feature. Technical Specifications Table 2. Technical Specifications Specification I/O Processor Chip Operating voltage Card size Array interface to host SAS/SATA bus speed SAS/SATA ports Physical and virtual drive support Firmware Compatible devices Cabling Redundant configuration Enclosure management Enclosure support Intel® RAID Controller RS2WC080 LSI*SAS2008 PCI* Express-SAS/SATA I/O Processor chip, 150MHz +3.3 V, +12 V Low profile, extended half-length (6.6" x 2.731") PCI Express* Revision 2.0, x8 lane width 5.0 Gb/s Up to 6 Gb/s per port, point-to-point 2x4 internal ports, up to 64 devices with expanders Up to 64 physical drives including up to 16 physical drives in up to 16 RAID arrays per controller Drives not configured as part of a RAID array can be configured as "pass through" drives in Non-RAID mode. Up to 16 MB in reflashable flash ROM • 2.5-inch and 3.5-inch SAS or SATA II drives including SSD drives • Non disk devices including expanders • Can support drives of mixed capacity • Small, thin cables that do not restrict airflow • Shared connectors for multiple drives 32 KB NVRAM and config-on-disk (COD) • In-band SES • SGPIO Assumes one SEP per enclosure 14 Intel® RAID Controller RS2BWC080 Hardware User's Guide