Intel S1400FP Specification update - Page 3

Monthly Specification Update Enterprise Platforms and Services Marketing Contents Preface...1 1. Nomenclature...1 2. Product Scope...1 Summary Tables of Changes 2 Errata ...4 1. Linux* Operating Systems are not supported on RSTe mode 4 2. UEFI Microsoft Windows Server 2008* R2 SP1 installation on SCU ports may fail under RSTe RAID mode ...4 3. UEFI Operating System installation is not supported on ESRT2 mode 4 4. HDD status LEDs do not function under specific configuration 5 5. RSTe GUI installation may fail if there are no devices attached to any onboard AHCI ports ...5 6. System may halt under specific BIOS configurations 5 7. Microsoft Windows 2003* x86 installation failure under Pass-through mode of SCU controller ...5 8. System may halt under unsupported configuration in ESRT2 mode 6 9. Integrated BMC Web Console - Power Statistics page - Minimum wattage reads as zero ...6 10. Integrated BMC Web Console - Power Control page - Perform Action button not functional ...6 11. IPMI Get Chassis Status command returns incorrect Chassis Identify State. .........7 12. The BIOS and ME Firmware can't be updated successfully using Intel® One Boot Flash Update Utility(OFU) under SuSE* Linux Enterprise Server 11 (64-bit) with SP2 7 13. BMC continuously sends HDD assert/de-assert event during HDD RAID rebuild under ESRT2 mode of the SCU controller 7 14. High CPU utilization may occur when installing or running Microsoft Windows Server 2008* R2 or Microsoft Windows* 7 with default NIC driver for Intel® Gigabit ET Dual Port Server Adapter E1G42ET and Intel® Gigabit ET Quad Port Server Adapter E1G44ET.....8 15. Intel® LAN driver installation failure on Microsoft Windows* 7 8 16. Hard drives connected through SAS expander can't be detected in legacy mode ..8 17. On-board VGA cannot be set to the highest resolution (1920x1080 and higher) ....9 18. Hard drive locate LED may not instantly respond to the locate command if backplane is connected through SAS expander to a RAID controller 9 19. Some log names in SEL are displayed incorrectly after pressing the power button to shut down Microsoft Windows 2008* R2 64bit 9 20. Fault LED on 4x3.5" hot swap HDD cage may not function normally during RAID rebuilding with AHCI ESRTII RAID configuration 10 21. Integrated BMC Web Console - Sensor Readings Page - Memory Throttling sensor status will stay "Critical" once triggered 10 22. WOL (Wake on LAN) may not function under Red Hat* Linux 6.2 64bit OS .........10 Documentation Changes ...11 III