Intel SR1530 User Guide - Page 59

Replacing the Processor Note: This manual assumes a processor is already installed and you are referring to these steps to replace your processor. If you are setting up this system for the first time, see the Quick Start User's Guide that was included in the product box. Caution: Use only processors that have been validated to work with this server board. See "Server System References" on page x for a link to the list of compatible processor(s). Caution: ESD and handling processors: Reduce the risk of electrostatic discharge (ESD) damage to the processor by doing the following: (1) Touch the metal chassis before touching the processor or server board. Keep part of your body in contact with the metal chassis to dissipate the static charge while handling the processor. (2) Avoid moving around unnecessarily. Removing the Heat Sink and Processor 1. Observe the safety and ESD precautions at the beginning of this book. See "Safety Information" on page iii. 2. Power down the server and unplug all peripheral devices and the AC power cable. 3. Remove the server system cover. For instructions, see "Removing the Server System Cover" on page 28. 4. Loosen the four captive screws on the corners of the heat sink. 5. Twist the heat sink slightly to break the seal between the heat sink and the processor. 6. Lift the heat sink from the processor. If it does not pull up easily, twist the heat sink again. Do not force the heat sink from the processor. Doing so could damage the processor. 7. Lift the processor lever. 8. Raise the CPU load plate. 9. Remove the processor. 10. If installing a replacement processor, see "Installing the Processor" on page 38. Otherwise, install the protective socket cover over the empty processor socket and then reinstall the chassis cover. Intel® Server System SR1530AH / SR1530AHLX / SR1530HAHLX 37