Intermec CV61 CV61 Compliance Insert

1

CV61 Compliance Insert

Models 1011CM01

For Users in English-Speaking Regions (en)

The users of this product are cautioned to use accessories and peripherals approved by Intermec Technologies Corporation. The use of

accessories other than those recommended, or changes to this product that are not approved by Intermec Technologies Corporation, may void

the compliance of this product and may result in the loss of the user’s authority to operate the equipment.

Battery Information

Battery Recycling Information

802.11 Radio Precaution Statement

Radiation Exposure Statement

Use of antennas and accessories not authorized may void the compliance of this product and may result in RF exposures beyond the limits

established for this equipment.

When installing and using this product, a 20 cm (7.87 in) passing distance must be maintained from the body or head of the user or nearby

persons and the antenna. The antenna must not be touched during transmitter operation.

For Users in the U.S.A. and Canada

U.S.A. Digital Emissions Compliance

This device complies with part 15 of the FCC Rules.

Operation is subject to the following two conditions: (1) this device may not cause

harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules.

These

limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial

environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the

instruction manual, may cause harmful interference to radio communications.

Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the

interference at their own expense.

Caution: This marking indicates that the user should read all included documentation before use. Retain this supplement for future

reference.

Caution: For vehicle installations observe all warnings and cautions contained in the installation instructions. Installations

involving vehicle power sources at or above 60 VDC should be performed by a trained service professional to avoid injury or damage

to equipment.

Caution: For use with Intermec battery pack Model 1011AB01 only.

See battery instructions.

For power supply, use Intermec

Models 9006AE01, 851-070-001, AE10, or 9007AX01. No user-serviceable parts.

Caution: For continued protection against risk of fire, replace only with same type and rating of fuse.

Caution: The battery pack used in this device may ignite, create a chemical burn hazard, explode, or release toxic materials if

mistreated. Do not incinerate, disassemble, or heat above 100 °C (212 °F). Do not short circuit; may cause burns. Keep away from

children. Promply dispose of used batteries according to the instructions.

Li-ion

Li-ion

This product contains or uses a lithium-ion (Li-ion) main battery. When the battery reaches the end of its useful life, the spent

battery should be disposed of by a qualified recycler or hazardous materials handler. Do not mix this battery with the solid

waste stream. Contact your Intermec Technologies Service Center for recycling or disposal information.

Caution: Users are responsible for configuring the channels of operation that comply with their country regulatory standards.

A

Wireless Network Administrator should review the operating restrictions detailed within the Access Point installation manual.

Warning: This equipment complies with International Commission on Non-Ionizing Radiation Protection (ICNIRP), IEEE C95.1,

Federal Communications Commission Office of Engineering and Technology (OET) Bulletin 65, Canada RSS-102, and European

Committee for Electrotechnical Standardization (CENELEC) limits for exposure to radio frequency (RF) radiation.

Complies with

IDA Standards

DA 102905

S&E

XXXXXXXXXXX