Intermec FlexDock Dual Base Compliance Insert - Page 1

Dual Base Compliance Insert Model 1002UU03 S&E ME06 XXXXXX For Users in English-Speaking Regions (en) Caution: This marking indicates that the user should read all included documentation before use. Retain this supplement for future reference. The users of this product are cautioned to use accessories and peripherals approved by Intermec Technologies Corporation. The use of accessories other than those recommended, or changes to this product that are not approved by Intermec Technologies Corporation, may void the compliance of this product and may result in the loss of the user's authority to operate the equipment. This product may be configured for use with multiple Intermec devices. The following devices are currently certified for use with this product: Intermec Product Family CK70/CK71 CN70/CN70e CS40 Product Model 1001CP01* 1000CP01*/1000CP02* 1005CP01* Battery Pack Model 1001AB01, 1001AB02 1000AB01, 1000AB02 1005AB01 *Product Model numbers may include additional suffixes. This device can be configured by end users for their specific application. The following adapters have been have certified for use with this product: Intermec Product Family CK3 Series CK70/CK71 CN70/CN70e CS40 Product Adapter Model Not available. 1002UD02 1002UD01 1002UD06 Battery Adapter Model 1002UC02 1002UC02 1002UC01 1002UC05 Contact your local Intermec office for additional Intermec products and adapters that may be supported. For power supply use Intermec Model 9004AE01. Caution: The battery pack used in this device may ignite, create a chemical burn hazard, explode, or release toxic materials if mistreated. Do not incinerate, disassemble, or heat above 100 °C (212 °F). Do not short circuit; may cause burns. Keep away from children. For Users in the U.S.A and Canada U.S.A. Digital Emissions Compliance This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at their own expense. Canadian Compliance This device complies with Industry Canada license-exempt RSS standards. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. CAN ICES-3 (A)/NMB-3 (A) For Users in Europe EN 55022 / CISPR 22 Compliance Warning: This is a Class A product. In a domestic environment this product may cause radio interference in which case the user may be required to take adequate measures. EU Declaration Intermec Technologies Corporation declares that this device is in compliance with the essential requirements and other provisions of all applicable EU directives. To find the EU Declaration of Conformity, go to www.intermec.com > Products > Computers > Handheld Computers > FlexDock > Manuals tab and then scroll down to Regulatory Information. 1