Intermec IP30 IP30 (865 MHz) Compliance Insert - Page 1

IP30 (865 MHz) Compliance Insert For Users in English-Speaking Regions Caution: This marking indicates that the user should read all included documentation before use. Retain this supplement for future reference. Users of this product are cautioned to use accessories and peripherals approved by Intermec Technologies Corporation. The use of accessories other than those recommended, or changes to the product that is not approved by Intermec Technologies Corporation, may void the compliance of this product and may result in the loss of the user's authority to operate the equipment. Battery, Charger, and Power Supply Information Caution: For use with Intermec battery pack Model AB3 only. No user-serviceable parts. Charge only in or with Intermec Models AC6 and AC7. Use of incorrect charger may present a risk of fire or explosion. Promptly dispose of used battery pack according to the instructions. Caution: The battery pack used with this product may ignite, create a chemical burn hazard, explode, or release toxic materials if mistreated. Do not incinerate, disassemble, or heat above 100 °C (212 °F). Do not short circuit; may cause burns. Keep away from children. Battery Recycling Information Li-ion Li-ion This product contains or uses a lithium ion (Li-ion) main battery. When the battery reaches the end of its useful life, the spent battery should be disposed of by a qualified recycler or hazardous materials handler. Do not mix this battery with the solid waste stream. Contact your Intermec Technologies Service Center for recycling or disposal information. Radiation Exposure Statement Radio Wave Exposure and Specific Absorption Rate (SAR) Information Warning: This equipment complies with International Commission on Non-Ionizing Radiation Protection (ICNIRP), IEEE C95.1, Federal Communications Commission Office of Engineering and Technology (OET) Bulletin 65, Canada RSS-102, and European Committee for Electrotechnical Standardization (CENELEC) limits for exposure to radio frequency (RF) radiation. Use of antennas and accessories not authorized may void the compliance of this product and may result in RF exposures beyond the limits established for this equipment. When installing and using the Intermec IP30 RFID reader a 20-cm (8-inch) passing distance must be maintained from the body or head of the user or nearby persons and the IP30 antenna. The antenna must not be touched during transmitter operation. EU - R&TTE Declaration Intermec Technologies Corporation declares that this device is in accordance with the essential requirements and other provisions of R&TTE Directive (1995/5/EC). For a copy of the Declaration of Conformity, go to www.intermec.com > Products > RFID > Handheld Readers > IP30 > Manuals tab and then scroll down to Regulatory Information. 0981 This product is marked with this logo and uses radio frequency bands that are not harmonized throughout the European Community and other countries as noted in the table below. Bluetooth and 802.11b/g Radio Mode: The transmitter output power is 9.8 mW EIRP. The following table indicates the areas of intended use of the equipment and any known restrictions. (Revision ERC/REC 70-03 E 2012-03, Annex 3 Band A) This equipment may be operated in the following countries without restriction. AT BE CY CZ DK EE FI FR DE GR HU IE LV LT MT NL PL PT SK SI ES SE GB IS LI CH BG RO TR 1