Intermec PB22 Media Core Installation Instructions
Intermec PB22 Manual
View all Intermec PB22 manuals
Add to My Manuals
Save this manual to your list of manuals |
Intermec PB22 manual content summary:
- Intermec PB22 | Media Core Installation Instructions - Page 1
Instructions The PB22 and PB32 printers support the use of media that have a core with an inside diameter of 19.05 mm (0.75 inch) and 10.16 mm (0.4 inch). Printers instructions To install the optional media core 1 Remove the self-tapping screw using a Torx T10 driver. 2 Remove the manual lock. - Intermec PB22 | Media Core Installation Instructions - Page 2
to prevent the media core from turning when you tighten the screw. 5 Reverse Steps 1 through 3 to reassemble the printer with the new media core. Media Core Installation Instructions *931-063-001* P/N 931-063-001 Worldwide Headquarters 6001 36th Avenue West Everett, Washington 98203 U.S.A. tel 425
The PB22 and PB32 printers support the use of media that have a core with an
inside diameter of 19.05 mm (0.75 inch) and 10.16 mm (0.4 inch). Printers are
shipped with a 19.05 mm media core installed. If you are using media with an inside
diameter of 10.16 mm, you will need change to this new media core.
You will find the following items in the shipping box:
•
Two 10.16 mm (0.4 inch) media cores
•
These installation instructions
To install the optional media core
1
Remove the self-tapping screw using a Torx T10 driver.
2
Remove the manual lock.
Media Core Installation Instructions