Intermec PD41 Cutter for PD41/PD42 Installation Instructions
Intermec PD41 Manual
 |
View all Intermec PD41 manuals
Add to My Manuals
Save this manual to your list of manuals |
Intermec PD41 manual content summary:
- Intermec PD41 | Cutter for PD41/PD42 Installation Instructions - Page 1
Installation Instructions Cutter Kit for the EasyCoder® PD41 and PD42 Printers - Intermec PD41 | Cutter for PD41/PD42 Installation Instructions - Page 2
purpose of allowing customers to operate and service Intermec-manufactured equipment and is not to be released, reproduced, or used for any other purpose without written permission of Intermec Technologies Corporation. Information and specifications contained in this document are subject to change - Intermec PD41 | Cutter for PD41/PD42 Installation Instructions - Page 3
Two screws Two cable clips Cutter cover Cutter spring Two screws (for plastic) 2 Make sure the printer is turned off and disconnected from the power supply. Remove the screw that holds the front cover. Remove the front cover. EasyCoder PD41/PD42 Cutter Kit Installation Instructions - Intermec PD41 | Cutter for PD41/PD42 Installation Instructions - Page 4
3 Open the side door and remove the tear bar, held by two Phillips screws. 4 Attach the cutter mechanism to the printer using the two Phillips screws included in the kit. EasyCoder PD41/PD42 Cutter Kit Installation Instructions - Intermec PD41 | Cutter for PD41/PD42 Installation Instructions - Page 5
the cutter spring to the cover (1). Hook the cutter cover onto the cutter mechanism and lock the cover with the screw at the bottom (2). 1 2 EasyCoder PD41/PD42 Cutter Kit Installation Instructions - Intermec PD41 | Cutter for PD41/PD42 Installation Instructions - Page 6
display. To activate the cutter on a PD42 printer 1 Turn the printer on. 2 Press Setup ( ). 3 Navigate Please refer to the Fingerprint Programmer's Reference Manual (P/N 937-005-xxx) for more Please refer to the IPL Programmer's Reference Manual (P/N 066396-xxx) for more information. IPL - Intermec PD41 | Cutter for PD41/PD42 Installation Instructions - Page 7
the printer, follow the instructions provided in the printer's user's guide. The cutter is primarily intended to cut paper-based media in the form of continuous stock. To obtain optimal use of the cutter, make sure your media corresponds to the specification below. Recommended minimum label/paper - Intermec PD41 | Cutter for PD41/PD42 Installation Instructions - Page 8
Intermec Technologies Corporation Worldwide Headquarters 6001 36th Avenue West Everett, WA 98203 U.S.A. tel 425.348.2600 fax 425.355.9551 www.intermec.com EasyCoder PD41/PD42 Cutter Kit Installation Instructions *1-960657-01* P/N 1-960657-01
-
1 -
2 -
3 -
4 -
5 -
6 -
7 -
8
 |
 |
Installation
Instructions
Cutter Kit
for the EasyCoder®
PD41 and PD42 Printers