Intermec PD41 Cutter for PD41/PD42 Installation Instructions - Page 7
Installing Media
 |
View all Intermec PD41 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
Installing Media To install media in the printer, follow the instructions provided in the printer's user's guide. The cutter is primarily intended to cut paper-based media in the form of continuous stock. To obtain optimal use of the cutter, make sure your media corresponds to the specification below. Recommended minimum label/paper length Maximum label/paper width Recommended media thickness 30 mm 114 mm 78 - 175 μm Configure your cutter so that it only cuts through the label liner. If you cut through both label and liner, the adhesive sticks to the cutting blade and this causes malfunction. Also avoid cutting soft, plastic-based media. EasyCoder PD41/PD42 Cutter Kit Installation Instructions
-
1 -
2 -
3 -
4 -
5 -
6 -
7 -
8
 |
 |
EasyCoder PD41/PD42 Cutter Kit Installation Instructions
´
Installing Media
To install media in the printer, follow the instructions provided in the printer’s
user’s guide. °e cutter is primarily intended to cut paper-based media in the
form of continuous stock. To obtain optimal use of the cutter, make sure your
media corresponds to the specification below.
Recommended minimum label/paper length
30 mm
Maximum label/paper width
114 mm
Recommended media thickness
78 - 175 μm
Configure your cutter so that it only cuts through the label liner.
If you cut through both label and liner, the adhesive sticks to the
cutting blade and this causes malfunction. Also avoid cutting
soft, plastic-based media.