Intermec PF2i EasyCoder PF2i RFID Kit Installation Instructions - Page 13
Fingerprint Programmer's Reference Manual P/N 1-960582
View all Intermec PF2i manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
8 Remove the two screws that hold the interface cover plate. Remove the cover plate. 9 Remove the #T20 Torx screw fitted on the hexagonal spacer at the center of the CPU board. 10 If you do not already have a real-time clock installed, use the one supplied with the kit. Slide it into its designated slot on the main board, marked "RTC & PROGRAM KEY". RTC & PROGRAM KEY For mP35ore information on hoJ6w2 to set the real-time clock please refer to the Fingerprint Programmer's Reference Manual (P/N 1-960582XX). 11 ConJ61nect the single-slot I/O cable to connector J62 (marked "EXP BOARD") on the CPU board. EXP BOARD RFID Kit for the EasyCoder PF2i Printer Installation Instructions
RTC & PROGRAM KEY
RFID Kit for the EasyCoder PF2i Printer Installation Instructions
¶
8
Remove the two screws that hold the interface cover plate. Remove
the cover plate.
9
Remove the #T20 Torx screw fitted on the hexagonal spacer at the
center of the CPU board.
10
If you do not already have a real-time clock installed, use the one
supplied with the kit. Slide it into its designated slot on the main
board, marked “RTC & PROGRAM KEY”.
For more information on how to set the real-time clock please refer
to the
Fingerprint Programmer’s Reference Manual (P/N 1-960582-
XX)
.
11
Connect the single-slot I/O cable to connector J62 (marked “EXP
BOARD”) on the CPU board.