Invacare 3GARBASE Owners Manual 2 - Page 74
Using Mechanical Elevating/Genius Legrests, Installing/Removing Mechanical Elevating/Genius,
View all Invacare 3GARBASE manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 74 highlights
SECTION 6-FRONT RIGGINGS CONTROLLER TRCM version 2.2 or earlier TAC version 1.1 or earlier TRCM version 2.3 or higher TAC version 1.11 or higher LEG UP SPEED 70% or higher 40% or higher LEG DOWN SPEED 50% or higher 35% or higher Using Mechanical Elevating/Genius Legrests CAUTION DO NOT operate the recline function of the seating system if one or both of the mechanical elevating legrest push rods is bent. Damage to the seating system can occur. NOTE: For this procedure, refer to FIGURE 6.16. NOTE: These procedures apply to wheelchairs with 2G Tarsys seating systems only. Mechanical elevating legrests are linked to the recline function of the seating system. Operating the recline function automatically operates elevating legrests. Mechanical Elevating Legrest Push Rod Pin FIGURE 6.16 Using Mechanical Elevating/Genius Legrests Installing/Removing Mechanical Elevating/Genius Legrests NOTE: For this procedure, refer to FIGURE 6.17 on page 75. NOTE: These procedures apply to wheelchairs with 2G Tarsys seating systems only. Installing 1. Turn elevating legrest to side (open footplate is perpendicular to wheelchair) and position the mounting pin on the legrest mounting holes on the seat frame. 2. Insert the mounting pin into the mounting hole. NOTE: Make sure the legrest sits flush on the seat frame. 3. Rotate the elevating legrest toward the inside of the wheelchair until it locks in place. NOTE: The footplate will be on the inside of the wheelchair when locked in place. 3G Storm Series® Wheelchairs 74 Part No 1134791