Invacare 9RC Owners Manual - Page 42
Bolt-In-Place Height
View all Invacare 9RC manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 42 highlights
5 FRONT RIGGINGS Bolt-In-Place Height This procedure applies to the swingaway front riggings and swingaway elevating legrest. 1. Remove the swingaway front rigging. Refer to Installing/Removing Front Riggings on page 39. Lay the front rigging assembly on a flat surface to simplify this procedure. 2. Pull the cam lock lever up to position. 3. Using a screw driver to hold the threaded rivet in position, remove the button head screw from the threaded rivet. 4. Remove the threaded rivet and button head screw securing the footplate assembly to the front rigging support. 5. Adjust the footplate assembly height by aligning the desired adjustment holes in the upper front rigging support and lower footplate assembly. 6. From the outside of the swingaway front rigging, insert the threaded rivet through both the front rigging support and the footplate assembly. 7. From the inside of the swingaway front rigging, insert the button head screw through the appropriate adjustment hole and thread into the threaded rivet. 8. Using a screwdriver to hold the threaded rivet in position, securely tighten the button head screw. Torque to 32 in-lbs. 9. Rotate cam lock lever down to locked position. 10. Repeat STEPS 1-9 to adjust the remaining footrest. Invacare® 9000 Series Wheelchair 42 Part No. 1056953