Invacare TDXSIV-2 Owners Manual 2 - Page 85
Installing Batteries into Wheelchair
View all Invacare TDXSIV-2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 85 highlights
7 SETUP/MAINTENANCE Installing Batteries into Wheelchair For this procedure, refer to FIGURE 2 on page 84 and FIGURE 3 on page 86. Positioning of the batteries into the battery tray is completed with battery tray positioned in wheelchair and partially pulled out. Refer to FIGURE 2 for full view of wheelchair base. Illustrations in FIGURE 3 on page 86 are shown without the wheelchair for clarification purposes only. 1. Position the battery with battery connector bracket in the rear of the battery tray in the orientation as shown. See Detail "A" of FIGURE 3 on page 86. Front of battery tray is designated by the battery stop. Rear of the battery tray is the opposite end. Orientation of the battery is critical otherwise batteries will not connect to the controller or each other. 2. Position the remaining battery in the front of the battery tray in the orientation shown so that the wiring harnesses can be connected together. See Detail "B" of FIGURE 3 on page 86. 3. Connect front battery to rear battery. See Detail "B" of FIGURE 3 on page 86. 4. Connect battery straps. See Detail "C" of FIGURE 3 on page 86. 5. Slide the battery tray into the wheelchair (FIGURE 2). 6. Install the battery door and rear shroud. Refer to Installing the Front Shroud/Battery Retention Bracket and Rear Shroud on page 87. Part No 1154294 85 Invacare® TDX®SI Series