Invacare TREX20RP Owners Manual - Page 53
Adjusting the Anti-Tippers
View all Invacare TREX20RP manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 53 highlights
10 ANTI-TIPPERS/WHEEL LOCKS A 11/2 to 2 inch clearance between the bottom of the anti-tipper wheels and the ground/floor MUST be maintained at all times. 5. If the distance between the bottom of anti-tipper wheels and the ground/floor is not 11/2 to 2 inches, adjust anti-tippers. Refer to Adjusting the Anti-Tippers on page 53. Adjusting the Anti-Tippers A 11/2 to 2 inch clearance between the bottom of the anti-tipper wheels and the ground/floor MUST be maintained at all times. 1. Place the wheelchair on a flat surface. If adjusting anti-tippers on recliner models, ensure back canes are in the upright position before making adjustments. 2. Press the release buttons on the wheeled portion of the anti-tipper and slide it up or down to the desired adjustment hole. 3. Check to make sure that the release buttons are fully engaged in adjustment holes. 4. Ensure both anti-tippers are adjusted to the same height. 5. Measure the distance between the bottom of the anti-tipper wheels and the ground/floor. 6. If the distance between the bottom of anti-tipper wheels and the ground/floor is not 11/2 to 2 inches, repeat steps 2-5 until the distance is 11/2 to 2 inches. 7. If the 11/2 to 2 inch distance cannot be achieved, a different model may be required. Contact an Invacare dealer or qualified technician. Release Buttons 11/2 to 2 inch Clearance FIGURE 3 Adjusting the Anti-Tippers Part No 1110546 53 Invacare® Tracer™ EX2 Wheelchair