Invacare TRSX5 Owners Manual - Page 50
Replacing Rear Wheel Handrim
View all Invacare TRSX5 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 50 highlights
8 REAR WHEELS 1. Remove the dust cap (SA Frame only), hex screw, washer (SA Frame only), spacer (if installed) and locknut that secure the rear wheel to the wheelchair frame. The spacer is used on wheelchairs with removable arms only. 2. Repeat STEP 1 for the opposite rear wheel if desired. 3. To reinstall the rear wheel(s) onto the wheelchair, reverse STEPS 1-2 and torque locknut to 40 ft.-lbs. 4. Adjust wheel locks. Refer to Using/Adjusting Patient Operated Wheel Locks on page 57. Rear Wheel Washer (SA Frame ONLY) Axle Mounting Axle Dust Cap (SA Frame ONLY) Hex Screw Locknut Wheelchair Frame Spacer (Wheelchairs with Removable Arms ONLY) FIGURE 1 Removing/Installing Rear Wheels - Permanent Axles 8.2 Replacing Rear Wheel Handrim ƽ WARNING If the wheelchair is equipped with permanent axles, this procedure MUST be performed by a qualified technician. 1. Remove the rear wheel from the wheelchair. For non-recliner models, refer to Removing/Installing Rear Wheels on page 49. For recliner models, refer to Removing/Installing the Rear Wheels on page 71. 2. Remove the mounting screws that secure the handrim to rear wheel. 3. Remove the existing handrim. 4. Secure the new handrim to the rear wheel with mounting screws. Tighten securely. 5. Reinstall rear wheel to the wheelchair. Refer to Removing/Installing Rear Wheels on page 49. Invacare® Tracer® SX5 Wheelchair 50 Rear Wheel Handrim Mounting Screw FIGURE 2 Replacing Rear Wheel Handrim Part No. 1110550