JET Tools JLP-150A-20 User Manual - Page 11
Precautions,
View all JET Tools JLP-150A-20 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
Precautions During pulling operations, the operator should stand near the side of the top hook on the opposite side of the lever. If the hand should slip off the lever, the lever will spring back away from the operator, (Fig. 7). During lifting operations, do not stand under the load. Do not use an extension on the lever (A, Fig. 8). Do not use a foot to apply pressure to the lever (B, Fig. 8). Prevent the chain from dragging over sharp edges or corners. These will cause links to weaken, bend, or break, (Fig. 9). When using a wire rope sling, the puller must be applied along a straight line parallel to the surface on which it is resting (Fig. 10). When lifting loads, hook the load with slings. Do not use the lever hoist chain as a sling, (Fig. 11). Both ends of a sling or rope must be completely on the inside of the safety latch before pulling or lifting the load. Do not put one end on the inside of the latch and leave the other end on the hook end outside the latch. Figure 7 Figure 8 Figure 9 Figure 10 Figure 11 11