JVC DLA-QX1G Instruction Manual - Page 14

Controls and Features (cont.) Connector Panel 1 CONTROL REMOTE 2 3 RS-232C OUT RS-232C IN RGB Analog VIC 4 5 B G R V H/CS 6 1 REMOTE terminal (mini jack) This terminal is used to directly connect the remote control unit to the projector. Use the remote control cable supplied. 2 RS-232C OUT terminal (D-sub 9 pin) This is an RS-232C interface-specified terminal. When another DLA-QX1G is connected to this projector using this terminal, you can enable a computer to control plural DLA-QX1Gs at the same time. For details, consult your dealer. 3 RS-232C IN terminal (D-sub 9 pin) This is a RS-232C interface-specified terminal. This projector can be controlled by a computer connected externally. For details, consult your dealer. 4 LED This LED lights up when the RGB Analog VIC is selected. 5 RGB IN terminals (BNC x 5) These are multipurpose video input terminals that allow input of the following signals. • Analog RGB signals, vertical sync (V) signals, and horizontal sync (H) signals / composite signals (Cs). (Devices which have analog RGB signal output terminals can be connected.) * Input of external sync signals is automatically detected. Detection of H/V signals or Cs signals causes automatic switching to external sync. The priority order is H/V > Cs. • The uppermost edge of the image may appear to bow if the sync signal input is composite sync (Cs) or G on sync signal. In this case, use separate sync signals for vertical sync (V) and horizontal sync (H). 6 VIC slots (x 2) You can install the optional VICs in this projector using these slots. The following VICs are available. • HDTV Analog VIC This VIC enables the projector to be input the conventional HDTV signal (Y, Pb, and Pr). • HD-SDI VIC This VIC enables the projector to be input and output the HD-SDI signal. The output terminal can be used as a line through terminal for checking the input signal by connecting the HD-SDI monitor or for using plural projectors at the same time. For details, refer to page 13. 12