JVC FS-A52 Instruction Manual - Page 26

Playing Back a Tape You can play back type I, II, and IV tapes. 1 Press TAPE open/close 0 on the unit. The unit automatically turns on, the electronic swing panel slides downward, and the cassette loading slot appears. If a cassette is already in the cassette loading slot, it is ejected. cassette loading slot To stop during play, press 7. To fast-wind or rewind the tape, press ¢ or 4. • When the tape direction is ¢ : Fast-winds the tape. 4 : Rewinds the tape. • When the tape direction is 4 : Fast-winds the tape. ¢ : Rewinds the tape. To eject the cassette, press TAPE open/close 0. • After ejecting the cassette, press TAPE open/close 0 again to close the electronic swing panel. DO NOT press TAPE open/close 0 during tape play. 2 Insert a cassette with the exposed part facing left. The cassette is pulled in, then the electronic swing panel slides upward automatically. 3 Press TAPE 2 3. The tape starts playing. • Each time you press the button, the tape direction changes as follows: : Plays the front side. : Plays the reverse side. Tape indicator To play both sides-Reverse Mode You can set the cassette deck to play just one side of a tape, both sides once, or both sides continuously. • You can set this mode only when a cassette is already in the cassette deck. On the remote control ONLY: Press REV. MODE. • Each time you press the button, the reverse mode changes as follows: : To only play back one side (front or reverse.) : To play back the front and reverse sides once. : To play back both front and reverse sides continuously. To check the clock time while playing back a tape On the remote control ONLY: Press DISPLAY (not on number buttons.) • Each time you press the button, the source information and the clock time alternate on the display. The use of the C-120 or thinner tape is not recommended, since characteristic deterioration may occur and this tape easily jams in the pinch rollers and the capstans. Reverse mode Tape direction When the tape plays to the end, the cassette deck automatically stops if the reverse mode is set to or . (See "To play both sides-Reverse Mode".) - 23 -