JVC FS-P5 Instruction Manual - Page 10

AM antenna ] ] Connecting Speakers 1 2 3 ANTENNA Vinyl-covered wire (not supplied) 1 AM EXT AM LOOP FM 75 COAXIAL Red RIGHT LEFT MAIN SPEAKERS SPEAKER IMPEDANCE MIN 6 Black Speaker cords 2 AM loop antenna (supplied) 1 Connect the AM loop antenna to the AM LOOP terminals as illustrated. • If the AM loop antenna wire is covered with vinyl, remove the vinyl by twisting it as shown in the diagram. 2 Turn the AM loop antenna until you have the best reception. To connect an outdoor AM antenna When reception is poor, connect a single vinyl-covered wire to the AM EXT terminal and extend it horizontally. (The AM loop antenna must remain connected.) For better reception of both FM and AM • Make sure the antenna conductors do not touch any other terminals and connecting cords. • Keep the antennas away from metallic parts of the unit, connecting cords, and the AC power cord. Right speaker Left speaker 1 Press and hold the clamp of the speaker terminal on the rear of the unit. 2 Insert the end of the speaker cord into the terminal. Match the polarity of the speaker terminals: Red (+) to red (+) and black (-) to black (-). 3 Release the finger from the clamp. IMPORTANT: Use only speakers with the same speaker impedance as indicated by the speaker terminals on the rear of the unit. - 7 -