JVC GZMG630RUS Instructions - Page 37

FURTHER INFORMATION Changing the Menu Settings 1 Touch MENU. 2 Select the desired menu. 3 Select the desired setting.  To return to the previous screen Select @.  To quit the screen Select [QUIT]. Troubleshooting Before requesting service, consult the following chart. If the solutions indicated in the chart do not solve the problem, consult your nearest JVC dealer or JVC service center for instructions. Refer also to the FAQ of new products on JVC's website. The following phenomena are not malfunctions. • The camcorder heats up when it is used for a long time. • The battery heats up during charging. • When playing back a video, the image stops momentarily or the sound is interrupted at junctions between scenes. • LCD monitor momentarily become red or black when sunlight is recorded. • Black spots, or red, green, or blue spots appear on the LCD monitor. (The LCD monitor contains 99.99% effective pixels, but 0.01% of fewer pixels may be ineffective.) Power Display Trouble No power is supplied. The remaining battery display is not correct. The LCD monitor is difficult to see. Recording cannot be performed. Recording stops by itself. Action • Connect the AC adapter correctly. • Recharge the battery pack. • Fully charge the battery pack, run it down, and then recharge it again. • If the camcorder is used for long periods of time in high or low temperatures, or if the battery pack is repeatedly charged, the amount of remaining battery may not be displayed correctly. • The LCD monitor may be difficult to see if used in bright areas such as under direct sunlight. • Slide the mode switch to select the desired mode (! or #). • If the camcorder temperature increases, REC flashes in the LCD monitor and recording stops automatically to protect the HDD. Turn off the camcorder, wait for a while, and start recording again. • Move away from a place where the camcorder is affected by excessive sound or vibration (such as a concert hall). • A malfunction may occur in the HDD of the camcorder. In this case, record to a microSD card. • Insert a commercially available microSD card, and set each of the [REC MEDIA FOR VIDEO] and [REC MEDIA FOR IMAGE] to [SD]. • Recording stops automatically after 12 hours of continuous recording. EN 37 Recording