JVC KD-AVX44 Instructions - Page 556

A Connecting the external amplifiers You can connect amplifiers to upgrade your car stereo system. • Connect the remote lead (blue with white stripe) to the remote lead of the other equipment so that it can be controlled through this unit. • For amplifier only: - After you have connected the center speaker, make sure to activate the center speaker; otherwise, no sound comes out of the connected center speaker, see page 51 of the INSTRUCTIONS. - Disconnect the speakers from this unit, connect them to the amplifier. Leave the speaker leads of this unit unused. - You can switch off the built-in amplifier and send the audio signals only to the external amplifier(s) to get clear sounds and to prevent internal heat buildup. See page 53 of the INSTRUCTIONS. Remote lead Remote lead (Blue with white stripe) Front speakers Y-connector (not supplied for this unit) To the remote lead of other equipment Rear speakers JVC Amplifier JVC Amplifier Subwoofer Front speakers JVC Amplifier B Connections for external component playback KS-HP2 Cordless headphones (not supplied)*7 JVC Amplifier Center speaker *5 Audio cord (not supplied) *6 Firmly attach the ground wire to the metallic body or to the chassis of the car-to the place uncoated with paint (if coated with paint, remove the paint before attaching the wire). Failure to do so may cause damage to the unit. Video cord (not supplied) KV-MR9010 9-INCH WIDESCREEN MONITOR (not supplied) KV-CM1 Rear view camera (not supplied) Camcorder, Navigation System, etc. Audio/video cords (not supplied) *7 To listen to disc playback sound while in Dual Zone operations (see page 26 of INSTRUCTIONS). C Connecting external components When connecting the external components, refer also to the manuals supplied for the components and adapter. CAUTION: Before connecting the external components, make sure that the unit is turned off. You can connect a JVC CD changer (CD-CH)-CH-X1500, etc. to the CD changer jack. You can also connect the following components through the various JVC adapters. • Connection cords may need to be purchased separately. Component iPod Portable audio player with line output jacks Portable audio player with 3.5 mm stereo mini jack Adapter Model name Interface adapter for iPod Line input adapter AUX input adapter KS-PD100 KS-U57 KS-U58 When connecting an external component USB device USB cable-approx.1.2 m USB device You cannot connect a computer to the USB ( ) terminal of the unit. Connecting the iPod to the USB terminal You can connect the iPod to the USB terminal using the following cables: - To listen to the music: USB 2.0 cable (supplied for the iPod) - To watch the video: USB Audio and Video cable for iPod-KS-U20K (not supplied)*8 KS-U20K Apple iPod CD changer jack To disconnect the connector CD-CH / KS-PD100 / KS-U57 / KS-U58 Hold the connector top tightly (1), then pull it out (2). Apple iPod *8 When using the cable, make sure is selected for (see page 52 of the INSTRUCTIONS). USB 2.0 cable • iPod is a trademark of Apple Inc., registered in the U.S. and other countries. 4