JVC KD-R85MBS Instruction Manual - Page 22
Display Settings
View all JVC KD-R85MBS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 22 highlights
AUDIO SETTINGS DISPLAY SETTINGS HPF *3 OFF: All signals are sent to the front/rear speakers. ; LOW 100Hz / MID 120Hz / HIGH 150Hz: Audio signals with frequencies lower than 100 Hz/ 120 Hz/ 150 Hz are cut off from the front/rear speakers. FADER*4*5 R06 - F06 (00): Adjusts the front and rear speaker output balance. BALANCE*4 L06 - R06 (00): Adjusts the left and right speaker output balance. VOL ADJUST -05 - +05 (00): Presets the volume adjustment level of each source (compared to the FM volume level). Before adjustment, select the source you want to adjust. ("VOL ADJ FIX" appears if FM is selected.) AMP GAIN LOW POWER: Limits the maximum volume level to 30. (Select if the maximum power of each speaker is less than 50 W to prevent damaging the speakers.) ; HIGH POWER: The maximum volume level is 50. D.T.EXP (Digital Track Expander) ON: Creates realistic sound by compensating the high-frequency components and restoring the rise-time of the waveform that are lost in audio data compression. ; OFF: Cancels. L/O MODE*6 SUB.W / REAR: Selects whether rear speakers or a subwoofer are connected to the REAR/SW line out terminals on the rear panel (through an external amplifier). *3 For KD-AR959BS / KD-R950BT / KD-R85MBS / KD-AR855BT. *4 This adjustment will not affect the subwoofer output. *5 If you are using a two-speaker system, set the fader level to [00]. *6 For KD-R950BT / KD-R850BT. KD-AR959BS / KD-R950BT KD-R85MBS / KD-AR855BT / KD-R850BT 1 Press and hold MENU. 2 Turn the volume knob to make a selection (see the following table), then press the knob. Repeat step 2 until the desired item is selected. 3 Press MENU to exit. To return to the previous setting item or hierarchy, press G PTY. Default: XX DISPLAY DIMMER Selects the display and button illumination adjusted in the [BRIGHTNESS] setting. AUTO: Changes between the day and night adjustments when you turn off or on the car headlights.*1 ; ON: Selects the night adjustments. ; OFF: Selects the day adjustments. BRIGHTNESS Sets the button, display and USB input terminal brightness for day and night separately. 1 DAY / NIGHT: Select day or night. 2 Select a zone for setting. ( Illustration above) 3 Set the brightness level (00 to 31). (Default: DAY: 31 ; NIGHT: 15) SCROLL*2 ONCE: Scrolls the display information once. ; AUTO: Repeats scrolling at 5-second intervals. ; OFF: Cancels. *1 The illumination control wire connection is required. ( 27, 28) *2 Some characters or symbols will not be shown correctly (or will be blanked). 20