JVC KD-R860BT Instruction Manual - Page 34
Wiring connection, Part list for, installation
View all JVC KD-R860BT manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 34 highlights
Wiring connection (for KD-R860BT) Front output Rear/subwoofer output Vehicle dashboard Signal cord (not supplied) Fuse (10 A) JVC Amplifier*1 *1 Firmly connect the ground wire of the amplifier to the car's chassis to avoid damaging the unit. Remote wire (not supplied) Part list for installation (A) Faceplate Factory wiring harness (vehicle) Vehicle-specific Wiring Harness (separately purchased) To the steering wheel remote control adapter Recommended connection Blue: To power antenna Blue/white: To amplifier Brown (Not used) For more information: Metra Electronics: www.metraonline.com Scosche Industries: www.scosche.com 32 Antenna terminal Light blue/yellow STEERING WHEEL REMOTE Join the same color wires together. Blue/white: Remote (200 mA max.) Orange/white: Illumination Yellow: Battery 12 V Red: Ignition 12 V Black: Ground Gray: Front speaker (right) Gray/black White: Front speaker (left) White/black Purple: Rear speaker (right) Purple/black Green: Rear speaker (left)*2 Green/black *2 Microphone input jack ( 14) (B) Trim plate Ignition switch (C) Mounting sleeve Car fuse block Separate red wire Make this connection if your vehicle factory wiring harness does not have "12 V ignition switch" wire. *2 You can also connect a subwoofer speaker directly using this lead without an external subwoofer amplifier. For setting, 21, 22. (D) Wiring harness (E) Extraction key