JVC KD-X200 Instruction Manual - Page 19
Installation/Connection - parts
View all JVC KD-X200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 19 highlights
Installation/Connection Part list for installation (~) Facepl ate (x 1) ($) Mounting sleeve (xl) © Trim plate (x l) ~ © Wiring harness (xl) A Warning • The unit can only be used with a 12 V DC power supply, negative ground. • Disconnect the battery's negative terminal before wiring and mounting. • Do not connect tbe Battery wire (yellow) and Ignition wire (red) tothecar chassis or Ground w ire (black} toprevent$blo rt circuit. • Insulate unconnected wires with vinyl tape to prevent short circuit. • Be sure to ground thisunit to the .... /"'t ro,... installation. ® Extraction keys (x2) ]] IBasic procedure 1 Remove the key from the ignition switch, then disconnect thee terminal of the car battery. 2 Connect the wires properly. (~page 21) 3 Install the unit to your car.(~ page 20) 4 Reconnect the 8 terminal of the car battery. 5 Reset the unit.(~ page 2) ENGLISH I 19