JVC KD-X220 Instruction Manual - Page 19

Wiring connection JVC Amplifier*1 Signal cord (not supplied) *1 Firmly connect the ground wire of the amplifier to the car's chassis to avoid damaging the unit. Part list for installation (A) Faceplate Fuse (10 A) Rear/subwoofer output Antenna terminal Vehicle dashboard Remote wire (not supplied) Ignition switch Car fuse block Separate red wire Make this connection if your vehicle factory wiring harness does not have "12 V ignition switch" wire. *2 You can also connect a subwoofer speaker directly using this lead without an external subwoofer amplifier. For setting, 12. Light blue/yellow STEERING WHEEL REMOTE To the steering wheel remote control adapter Join the same color wires together. Blue/white: Remote (200 mA max.) Orange/white: Illumination Recommended connection Blue: To power antenna Blue/white: To amplifier Brown: Tel muting Yellow: Battery 12 V Red: Ignition 12 V Black: Ground Gray: Front speaker (right) Gray/black White: Front speaker (left) White/black Purple: Rear speaker (right) Purple/black Green: Rear speaker (left)*2 Green/black *2 (B) Trim plate Factory wiring harness (vehicle) (C) Mounting sleeve Vehicle-specific Wiring Harness (separately purchased) (D) Wiring harness For more information: Metra Electronics: www.metraonline.com Scosche Industries: www.scosche.com (E) Extraction key ENGLISH 19