JVC KS-AR7501D Instructions - Page 2
SPEAKER CONNECTIONS, Wired remote control unit: RM-RK130 purchased separately - arsenal
UPC - 046838029660
View all JVC KS-AR7501D manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 2 highlights
SPEAKER CONNECTIONS Connection varies depending on the number of the speakers used in your car. Select the appropriate connection referring to the following diagrams. Before connecting: Securely connect all the parts. If the connections are loose, due to contact resistance etc., heat will break out and may cause an accident. Secure and cover the cords with insulating tape and run them under the car mats. å When your receiver is equipped with Line Output, connect the Line Output (through the receiver) to the INPUT jacks on this unit. ∫ When your receiver is NOT equipped with Line Output, connect the provided speaker input connector (through the receiver) to the HIGH INPUT terminal on this unit. Subwoofer system 2-subwoofer system Subwoofer Note Use the subwoofers with an impedance of 1 Ω to 8 Ω for KS-AR7501D or 2 Ω to 8 Ω for KS-AR7001. 2-subwoofer system (2 amplifiers) Subwoofer Subwoofer Note Use the subwoofers with an impedance of 2 Ω to 8 Ω for KS-AR7501D or 4 Ω to 8 Ω for KS-AR7001. 4-speaker system plus subwoofer-5.1-channel (3 amplifiers) ARSENAL amplifier, etc. (purchased separately) Subwoofer Line Out (Center) Subwoofer Out ARSENAL amplifier, etc. (purchased separately) Center Speaker Subwoofer Subwoofer Note Incoming signals are emitted through the PRE OUT jacks. *1 Not provided for this unit. *2 Be sure to connect the both leads to the target speaker lead. *3 Be sure to connect the line output from the receiver to the left (L) jack on this unit. Wired remote control unit: RM-RK130 (purchased separately) Using JVC's wired remote control unit: RM-RK130 (purchased separately), you can adjust the bass boost in your seat without adjusting the BASS BOOST controller on the amplifier (see "CONTROLS" on page 3) . Note Set the BASS BOOST controller on the amplifier to MIN when you use RM-RK130. A Mount RM-RK130 on a firm surface, such as under the dashboard. B Connect RM-RK130 to the REMOTE terminal on the amplifier with the Remote Cord provided for RM-RK130. C The BASS BOOST controller boosts the 45 Hz frequency within the range of 0 dB to 18 dB. Adjust the level while listening to the sound. • The POWER lamp lights in green while RM-RK130 is turned on. A B Under the dashboard, etc. Drilled hole Remote Cord (provided for RM-RK130) C POWER lamp BASS BOOST controller Screw (Dia. 3/16 inch (4 mm) × 1/2 inch (12 mm)) (provided for RM-RK130) RM-RK130 2