JVC SX-WD10 Instruction Manual - Page 3
Connection, About Speaker Grille, Specifications
UPC - 046838021039
View all JVC SX-WD10 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 3 highlights
English Connection About Speaker Grille o Precautions Before connecting: • Turn off the power to the amplifier before connecting the speaker system; otherwise, the speakers may be damaged. • The impedance of the speaker is 6 K. If this does not match with the speaker impedance range indicated on the amplifier, you cannot connect this system to the amplifier. • The maximum power handling capacity of the SX-WD10 is 150 W. Excessive input will result in abnormal noise and possible damage. • Be sure to turn down the volume level on the amplifier to prevent unwanted noise before performing following operations: - Turning on or off other components - Operating the amplifier - Tuning FM stations - Fast-forwarding a tape - Continuously reproducing high frequency oscillation or high pitch electronic sounds - Connecting or disconnecting a microphone • When using a microphone, do not aim it at the speakers or use it near the speakers; otherwise, the howling which occurs may damage the speakers. • Before replacing the cartridge, always turn off the power both to the amplifier and to the turntable; otherwise, the clicking noise may damage the speakers. o To remove the speaker grille To remove the speaker grille, insert your fingers at the bottom of the speaker grille, then pull upward. To attach the speaker grille, put the projections of the speaker into the holes of the speaker grille. • Do not press the speaker grille strongly. o Connecting the speaker system to the amplifier • Twist and remove the insulation at the end of each speaker cord before connecting. G terminal (Black hoop) F terminal (Red hoop) Specifications Type : 2-way 3-speaker bass-reflex type Magnetically-shielded type Speaker unit Mid and low range : 10.5 cm (4 3/16 in.) wooden cone x 2 Tweeter : 2.0 cm (13/16 in.) wooden dome x 1 Frequency range : 150 W Impedance : 6 K Crossover frequency : 3.8 kHz Frequency range : 45 Hz to 50 000 Hz Sound pressure level : 85 dB/W•m Dimensions (WxHxD) : 270 mm x 1101 mm x 320 mm (10 /11 16 x 43 3/8 x 12 5/8 in.) Mass : 16 kg (36 lbs) Supplied accessories : Speaker cord (3 m) (1) Foot (3) Base (1) Screw (3) Design and specifications subject to change without notice. Silver Copper To the speaker F terminal of amplifier To the speaker G terminal of amplifier • Make sure to match the polarity (F and G); otherwise, the surround effect will become less effective. 3