JVC TM-2703SU TM-2703SU User Manual (40 pages) - Page 17

Initial Setup

Get JVC TM-2703SU - Promedia Series Monitor/receiver PDF manuals and user guides View all JVC TM-2703SU manuals
Add to My Manuals
Save this manual to your list of manuals

Page 17 highlights

Initial Setup Auto Tuner Setup If you have already run the Auto Tuner as part of the quick setup earlier in this guide, please skip ahead to "Channel Summary" to continue setting up your television. In Auto Tuner Setup, the TV automatically scans through all available channels, memorizing the active ones and skipping over blank ones or channels with weak signals. This means when you scan (using the CHANNEL +/- buttons) you will receive only clear, active channels. π† √® Press the MENU button To AUTO TUNER SETUP To operate INITIAL SETUP> AUTO TUNER SETUP TUNER MODE CABLE √® π† √® To choose CABLE or AIR To move to START To start Auto Tuner Setup SELECT BY OPERATE BY START EXIT BY EXIT Programming will take approximately 1 to 2 minutes. The auto tuner is finished when the message PROGRAMMING OVER! appears onscreen. Note: • Some cable systems experience interference from radio frequencies on cable Channel 95. You may delete this channel from your scan by removing the "X" next to it on the Channel Summary screen shown on the next page. • Noise Muting will not work during Auto Tuner Setup. TM2703U 17 17 7/30/03, 4:16:13 PM

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
Initial Setup
17
Auto Tuner Setup
If you have already run the Auto Tuner as part of the quick setup earlier in this guide, please
skip ahead to “Channel Summary” to continue setting up your television.
In Auto Tuner Setup, the TV automatically scans through all available channels, memorizing the
active ones and skipping over blank ones or channels with weak signals. This means when you
scan (using the C
HANNEL
+/– buttons) you will receive only clear, active channels.
Press the M
ENU
button
π
†
To AUTO TUNER SETUP
√
®
To operate
√
®
To choose CABLE or AIR
π
†
To move to START
√
®
To start Auto Tuner Setup
Programming will take approximately 1 to 2 minutes.
The auto tuner is finished when the
message
PROGRAMMING OVER!
appears onscreen.
Note:
•
Some cable systems experience interference from radio frequencies on cable Channel 95.
You may delete this channel from your scan by removing the “X” next to it on the Channel
Summary screen shown on the next page.
•
Noise Muting will not work during Auto Tuner Setup.
INITIAL SETUP
>
AUTO TUNER SETUP
START
SELECT
BY
OPERATE BY
EXIT BY
TUNER MODE
CABLE
EXIT
TM2703U
17
7/30/03, 4:16:13 PM