JVC XV BP1 Instructions - Page 30
Troubleshooting
UPC - 046838039577
View all JVC XV BP1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 30 highlights
BD320-JN_BUSAJJK_OM_ENG 8/31/09 12:16 PM Page 30 Troubleshooting Symptom Possible Cause Correction No power. • The power cord is disconnected. • Plug the power cord into the wall outlet securely. The power is on, but the player does not work. • No disc is inserted. • Insert a disc. No picture. • The TV is not set to receive video signal output. • Select the appropriate video input mode on the TV. • The video cable is not connected securely. • Connect the video cable securely. • The selected resolution is not capa- • Select another resolution using ble with your TV. RESOLUTION button. No sound. • The equipment connected with the • Select the correct input mode of the audio cable is not set to receive disc audio receiver so you can listen to signal output. the sound from the player. • The power of the equipment connect- • Turn on the equipment connected ed with the audio cable is turned off. with the audio cable. • The [AUDIO] options are set to the wrong position. • Set the [AUDIO] options to the correct position (see page 18). • The player is in reverse play, fast for- • Return to the normal playback. ward, slow motion or pause mode. The player does not start playback. • The disc is upside down. • An unplayable disc is inserted. • Insert the disc with the playback side down. • Insert a playable disc. (Check the disc type and regional code.) • The rating level is set. • Change the rating level. • The disc was recorded on another unit and was not finalized. The Remote Control • The Remote Control is not pointed at does not work properly. the remote sensor on the player. • Finalize the disc on that unit. • Point the Remote Control at the remote sensor of the player. • The Remote Control is too far from the player. • Operate the Remote Control closer to the player. The system does not • A state is unstable. function at all. • Unplug the power cord and then plug the power cord again after more than five seconds. 30