Jenn-Air JDS1750FS Dimension Guide - Page 4

JENN-AIR® DETAILED PLANNING DIMENSIONS 4 of 4 DOWNDRAFT RANGE DUCTING ARRANGEMENTS DUCTING CONFIGURATIONS 5" (12.7 cm) diameter duct 5" (12.7 cm) diameter to 31⁄41" x 10" (8.3 cm x 25.4 cm) transition elbow REAR DUCTING IN WALL TO ROOF 5" (12.7 cm) diameter duct 5" (12.7 cm) diameter wall cap REAR DUCTING THROUGH WALL TO OUTSIDE DUCTING REQUIREMENTS RANGE DUCT LENGTH DUCT SIZE 10' (3.0 m) or less* 5" (12.7 cm) diameter* Dual Fuel Between 10' (3.0 m) and 60' (18.3 m) 6" (15.2 cm) diameter 31⁄4" x 10" (8.3 cm x 25.4 cm) 10' (3.0 m) or less** 5" (12.7 cm) diameter** Electric Between 10' (3.0 m) and 60' (18.3 m) 6" (15.2 cm) diameter 31⁄4" x 10" (8.3 cm x 25.4 cm) *Dual fuel ranges must use 5" (12.7 cm) diameter for runs of 10' (3.0 m) or less. **May be used to vent straight out the back of the range and directly through the wall. CALCULATING MAXIMUM DUCTING LENGTH • M aximum ducting length is 60' (18.3 m). • E ach 90° elbow equals 5' (1.5 m) duct. • U se no more than three 90° elbows. • F lexible metal vent is not recommended. • Do not install two elbows together. NOTES: • F or ducting runs up to 30' (9.1 m), install range as shipped. • F or ducting runs of 31' (9.4 m) to 60' (15.2 cm), remove the restricter ring on the blower inlet housing. • F or altitudes above 4500' (1272.0 m), reduce recommended vent run by 20% for best performance. 5" (12.7 cm) to 6" (15.2 cm) diameter transition elbow 6" (15.2 cm) diameter wall cap THROUGH FLOOR BETWEEN JOISTS TO OUTSIDE DUCT-FREE INSTALLATION THROUGH RANGE FRONT IMPORTANT: Dimensional specifications are provided for planning purposes only. Do not make any cutouts based on this information. Refer to the Installation or Use & Care Guide before selecting cabinetry, verifying electrical/gas connections, making cutouts or beginning installation. All Jenn-Air® appliances are appropriately UL, CUL or CSA approved. 8894BdZw916