Jenn-Air JEC9530BDS Dimension Guide - Page 2

JENN-AIR® DETAILED PLANNING DIMENSIONS 30" ELECTRIC RADIANT Cooktop JEC9530BD - 297⁄8" x 47⁄8" x 211⁄2" 2 of 4 OPENING/CLEARANCE DIMENSIONS D* B A E B F e C FRONT VIEW Side Cabinet G H MODEL # JEC9530BD in cm A Width of combustible area above cooking surface (min.) 30 76.2 B Width from cooktop to fixed wall or other comCbaSbiudinesett ible material (min.) C Width to outer edge of outlet (min.) 21⁄2 6.4 10 25.4 D* Height to bottGom of uncovered wood or metal cabinet above cooking surface (min.) 30 76.2 E Horeimghettatlocabboitntoetm(moHfinu.)ncovered wood 18 45.7 F Height to top edge of outlet (min.) 12 30.5 G Depth of upper cabinet 13 33.0 H Depth from cutout to wall (min.) 3⁄4 1.9 I Width of cutout 291⁄8 74.0 J Depth of cutout 203⁄8 51.9 K Depth from cutout to front of countertop 21⁄8 5.4 e Recommended electrical access location *Dimension can be reduced by 6" (15.2 cm) when bottom of wood or metal cabinet is covered by not less than 1⁄4" (0.6 cm) flame retardant millboard covered with not less than No. 28 MSG sheet metal, 0.015" (0.4 mm) stainless steel, 0.024" (0.6 mm) aluminum or 0.020" (0.5 mm) copper. If installing a hood or microwave hood combination above the cooktop, follow the hood or microwave hood combination instructions for dimensional clearances above the cooking surface. ELECTRICAL REQUIREMENTS 240 volt, 60 Hz, 40-amp fused, grounded circuit is required. A dedicated circuit is recommended. 48" (121.9 cm) of 1⁄2" (1.3 cm) I.D. flexible cable is provided. LOCATION REQUIREMENTS • T o ensure cooktop base clearance, cabinet side walls need to be wider than the cutout. • If cabinet has a drawer, allow a 51⁄4" (13.3 cm) minimum clearance between countertop and top of drawer. COOKTOP OVER SINGLE WALL OVEN INSTALLATION REQUIREMENTS A • F or approved model number combinations, refer to the under counter label on the bottom of the cooktop burner box. • To install a cooktop over a single wall oven, refer to page 3. D* I H B F J Side VIEW K TOP VIEW - cutout Product dimension, cutout and installation specifications are provided for planning purposes only. Before installing any product, be sure to verify cutout dimensions and electrical/gas connections as actual product dimensions may vary. JRC120040A 07/2012