Jenn-Air JGC3115GS Dimension Guide - Page 2

JENN-AIR® DETAILED PLANNING DIMENSIONS 15" SINGLE-BURNER MODULAR GAS COOKTOP WITH WOK RING JGC3115G - 15" x 45⁄32" x 21" 2 of 2 OPENING/CLEARANCE DIMENSIONS A E* F B B G H e g C D FRONT VIEW Side Cabinet I J K J L SIDE VIEW M TOP VIEW - CUTOUT MODEL # JGC3115G in cm A Width of combustible area above cooking surface (min.) 15 38.1 B Width from cooktop to fixed wall or other combustible material (min.) 6 15.2 C Width to oSidueter edge of electrical outlet (recommCeanbidneet d) 9 22.9 D Width to gas supply line location (recommenIded) 12 30.5 E* Height to bottoJm of uncovered wood or metal cabinet above cooking surface (min.) 30 76.2 F Height to bottom of uncovered wood or metal cabinet (min.) 18 45.7 G Height to top edge of electrical outlet (min.) 18 45.7 H Height to gas supply line location (recommended) 18 45.7 I Depth of upper cabinet (recommended) 13 33.0 J Depth from cutout to wall (min.) 25⁄16 5.9 K Width of cutout (recommended) 143⁄8 36.5 L Depth of cutout (recommended) 203⁄8 51.8 M Depth from cutout to front of countertop 25⁄16 5.9 e Recommended electrical access location g Recommended gas supply line location *Dimension can be reduced by 6" (15.2 cm) when bottom of wood or metal cabinet is covered by not less than 1⁄4" (0.6 cm) flame retardant millboard covered with not less than No. 28 MSG sheet metal, 0.015" (0.4 mm) stainless steel, 0.024" (0.6 mm) aluminum or 0.020" (0.5 mm) copper. If installing a hood follow the hood or moricmroicwroavweahvoeohdoocodmcboimnabtiinoantiionnstraubcotivoeAntshfeorcooktop, dimensional clearances above the cooking surface. GAS REQUIREMENTS Natural Gas E* This cooktop is factory-set for use with natural gas. LP Gas Conversion B Conversion must be done by a qualified service technician. To convert to LP gas, use an LP gas conversion kit. ELECTRICAL REQUIREMENTS G H 120 volt, 60 Hz, AC only, 15-amp fused, electrical circuit is required. A time-delay fuse or dedicated circuit is recommended. e LOCATION REQUIREMENTS g C • T o ensure cooktop base clearance, cabinet side walls need to be wider than the cutout D • If cabinet has a drawer, allow a 4" (10.2 cm) minimum clearance between countertop and top of drawer. Drawer depth may need to be shortened to avoid interfering with the regulator. F B IMPORTANT: Dimensional specifications are provided for planning purposes only. Do not make any cutouts based on this information. Refer to the Installation Guide before selecting cabinetry, verifying electrical/gas connections, making cutouts or beginning installation. All Jenn-Air® appliances are appropriately UL, CUL or CSA approved. 8996AdZw217