Jenn-Air JGC3536GS Instruction Sheet - Page 7

High Altitude Conversions IMPORTANT: You must convert Propane gas with Propane gas high altitude kit Part Number W10686630 or Natural gas with Natural gas high altitude kit Part Number W10686629. If you need to convert Propane gas to Natural gas high altitude or Natural gas to Propane gas high altitude, you must convert the pressure regulator. For this, follow steps 1 through 3 of the necessary conversion. Natural Gas Orifice Spud Chart for High Altitude Conversion See chart in the "Natural Gas High Altitude Conversion Kit." Burner Locations 30" (76.2 cm) and 36" (91.4 cm) Models A B C AB B C A D C Standard and simmer burners A. Igniter electrode B. Orifice holder C. Orifice spud Dual flame burner A. Igniter electrode B. Orifice holder C. Orifice spud D. Orifice simmer IMPORTANT: Place Propane gas orifice spuds in plastic parts bag for future use and keep with package containing literature. 7. Replace burner bases and burner caps. IMPORTANT: Be sure that the electrode aligns with the notch or hole in the burner base. The igniter electrode is ceramic and could break during installation of the burner base. A E D A. Left rear burner B. Center burner C. Right rear burner D. Right front burner E. Left front burner 5. Remove all burner caps and burner bases. Be sure to keep the cap and base for each burner together. This will assure that the cap and base are reinstalled on the proper burner. A B C F E D B C A. Burner cap B. Electrode C. Burner base 8. Open shut-off valve in the gas supply line. The valve is open when the handle is parallel to the gas pipe. 9. Once you have completed converting all of the cooktop burners, test the cooktop for leaks by brushing on an approved noncorrosive leak-detection solution. If bubbles appear, a leak is indicated. Correct any leaks found. A. Gas tube opening B. Burner cap C. Burner base D. Orifice holder E. Igniter electrode F. Burner base notch or hole 6. To convert burners: ■■ Insert 7.0 mm nut driver down onto the gas orifice spud (C) and remove by turning it counterclockwise and lifting out. ■■ Set gas orifice spud aside. ■■ Replace with correct Natural gas orifice spud. See the Natural Gas Orifice Spud Chart. 10. Plug in cooktop or reconnect power. 11. Adjust valve according to the "Low Flame Height Adjustment" section. 7