Jenn-Air JGRP430WP Dimension Guide - Page 1
Jenn-Air JGRP430WP Manual
View all Jenn-Air JGRP430WP manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1 highlights
30" (76.2 CM), 36" (91.4 CM) AND 48" (121.9 CM) PRO-STYLE® GAS CONVECTION RANGES PRODUCT MODEL NUMBERS PRODUCT DIMENSIONS JGRP430W JGRP436W JGRP536W JGRP548W 30" (76.2 cm) models ELECTRICAL REQUIREMENTS A q A 120 volt, 60 Hz., AC only, 15-amp fused, electrical circuit is required. A time-delay fuse or circuit breaker is also recommended. It is recommended that a separate circuit serving only this range be provided. B q Electronic ignition systems operate within wide voltage limits, but proper grounding and polarity are necessary. Check that the outlet provides 120-volt power and is correctly grounded. GAS SUPPLY REQUIREMENTS Type of Gas Natural Gas: This range is design-certified by CSA International for use with Natural gas or, after proper conversion, for use with LP gas. q This range is factory set for use with Natural gas. The model/serial rating plate located under the console on the right-hand side has information on the types of C gas that can be used. If the types of gas listed do not include the type of gas available, check with the local gas supplier. E LP Gas conversion: Conversion must be done by a qualified service technician. No attempt shall be made to convert the range from the gas specified on the model/serial rating plate for use with a different gas without consulting the serving gas supplier. To convert to LP gas, use the LP gas conversion kit provided with your range and see the "Gas Conversions" section. The parts for this kit are in the literature package supplied with the range. Gas Supply Line D q Provide a gas supply line of ³⁄₄" (1.9 cm) rigid pipe to the range location. A smaller size pipe on longer runs may result in insufficient gas supply. With LP gas, piping or tubing size can be ¹⁄₂" (1.3 cm) minimum. Usually, LP gas suppliers determine the size and materials used in the system. NOTE: Pipe-joint compounds that resist the action of LP gas must be used. Do not use TEFLON®† tape. †®TEFLON is a registered trademark of E.I. Du Pont De Nemours and Company. LOCATION REQUIREMENTS 36" (91.4 cm) models IMPORTANT: To avoid damage to your cabinets, check with your builder or cabinet supplier to make sure that the materials used will not discolor, delaminate or sustain other damage. This oven has been designed in accordance with the requirements of UL and CSA International and complies with the maximum allowable wood cabinet B temperatures of 194°F (90°C). Mobile Home - Additional Installation Requirements The installation of this range must conform to the Manufactured Home Construction and Safety Standard, Title 24 CFR, Part 3280 (formerly the Federal Standard for Mobile Home Construction and Safety, Title 24, HUD Part 280). When such standard is not applicable, use the Standard for Manufactured Home Installations, ANSI A225.1/NFPA 501A or with local codes. In Canada, the installation of this range must conform with the current standards CAN/CSA-A240-latest edition, or with local codes. Mobile home installations require: C q When this range is installed in a mobile home, it must be secured to the floor during transit. Any method of securing the range is adequate as long as it conforms to the standards listed above. A E D Because Whirlpool Corporation policy includes a continuous commitment to improve Dimensions are for planning purposes only. For complete details, see Installation our products, we reserve the right to change materials and specifications without notice. Instructions packed with product. Specifications subject to change without notice. Page 1 of 2 Ref. W10349769A 1/4/11