Jenn-Air JMC2430WS Installation Instruction - Page 5

3. Remove junction box cover if it is present. 4. Install a UL listed or CSA approved conduit connector to the junction box. A 2. Fasten the bottom trim using 2 screws provided. Do not overtighten the screws. A. UL listed or CSA approved conduit connector 5. Route the flexible cable conduit from the microwave oven to the junction box through a UL listed or CSA approved conduit connector. 6. Tighten screws on conduit connector. 7. See "Electrical Connection Options Chart" to complete installation for your type of electrical connection. 3-Wire Cable with Ground from Home Power Supply to Microwave Oven Cable with 4 Wires A I B H C G A A. Two screws 3. Using 2 or more people, lift microwave oven partially into cabinet cutout. If a spacer kit has been installed, lift the microwave oven over it. NOTE: Open microwave oven door and push against seal area of microwave oven front frame when pushing microwave oven into cabinet. Do not push against outside edges. 4. Push against the front frame of the microwave oven to push oven into cabinet. Push microwave oven completely into cabinet and center in cabinet cutout. F D E A. Cable from home power supply B. Green (or bare) wires C. White wires D. 4-wire cable from microwave oven E. UL listed or CSA approved conduit connector F. Red (or black) wires G. Black wires H. UL listed wire connector I. Junction box 1. Connect the 2 black wires (G) together using a UL listed wire connector. 2. Connect the 2 white wires (C) using a UL listed wire connector. 3. Connect the 2 red (or black) wires (F) together using a UL listed wire connector. 4. Connect the 2 green (or bare) wires together using a UL listed wire connector. 5. Install junction box cover. Install Microwave Oven 1. Center bottom trim over the lower edge of the cabinet cutout. Using an ¹⁄₈" (0.32 cm) drill bit, predrill pilot holes through the bottom trim. NOTE: If a spacer kit has been installed, do not install the bottom trim. 5. Using an ¹⁄₈" (0.32 cm) drill bit, predrill pilot holes through the mounting rails on each side of the microwave oven. 6. Securely fasten microwave oven to cabinet using the 4 screws provided. Insert the screws through holes in mounting rails. Do not overtighten screws. A B B A. Mounting rail B. Four screws 7. Replace convection grid, turntable and support hub. 8. Reconnect power. 9. Display panel will light briefly, and the clock should appear in the display. 10. If display panel does not light, please reference the "Assistance or Service" section of the Use and Care Guide or contact the dealer from whom you purchased your microwave oven. 5