Jenn-Air JMW2427DS Installation Instruction - Page 4

Electrical Connection To properly install your oven, you must determine the type of electrical connection you will be using and follow the instructions provided for it here. ■ Oven must be connected to the proper electrical voltage, amperage, and frequency as specified on the model/serial/ rating plate. See the following illustration. A A. Model/serial/rating plate ■ Models rated from 7.3 to 9.6 kW at 240 volts (5.4 to 7.4 kW at 208 volts) require a separate 40-amp circuit. ■ Acircuit breaker is recommended. ■ Connect directly to the fused disconnect (or circuit breaker box) through flexible, armored or nonmetallic sheathed, copper cable (with grounding wire). See "Make Electrical Connection" section. ■ Flexible conduit from the oven should be connected directly to the junction box. ■ Do not cut the conduit. The length of conduit provided is for serviceability of the oven. ■ AUL listed or CSA approved conduit connector must be provided. ■ If the house has aluminum wiring, follow the procedure below: 1. Connect a section of solid copper wire to the ends of the flexible conduit leads. 2. Connect the aluminum wiring to the added section of copper wire using special connectors and/or tools designed and UL listed for joining copper to aluminum. Follow the electrical connector manufacturer's recommended procedure. Aluminum/copper connection must conform with local codes and industry-accepted wiring practices. For power requirements, refer to the following table: Amperage Amperage Rating Model Voltage (L1)* (L2)* (W) JMW2430D 30 JMW2427D 208 28 6507 JMW3430D 31 28 6492 JMW2430D 32 JMW2427D 240 30 7503 JMW3430D 33 30 7491 *Amperage values noted above are for information purposes only: The units are rated in watts. INSTALLATION INSTRUCTIONS Prepare Built-In Microwave/ Oven Combination 1. Decide on the final location for the oven. Locate existing wiring to avoid drilling into or severing wiring during installation. WARNING Excessive Weight Hazard Use two or more people to move and install oven. Failure to do so can result in back or other injury. Remove Oven Door(s) IMPORTANT: Use two hands to remove oven door. 1. Prior to removing the oven door, prepare a surface where you will place it. This surface should be flat and covered with a soft blanket, or use the corner posts from your packaging material. 2. Open the oven door. 3. Locate the oven door hinge locks in both corners of the oven door, and then rotate the hinge locks toward the oven door to the unlocked position. If the door hinge lock is not rotated fully (see illustration B), the door will not remove properly. 2. To avoid floor damage, set the oven onto cardboard prior to installation. Do not use handle or any portion of the front frame for lifting. 3. Remember to remove bottom vent from the foam packing on top of oven. 4. Remove the shipping materials and tape from the oven. 5. Remove the hardware package from inside the bag containing literature. 6. Remove and set aside racks and other parts from inside the oven. 7. Move oven and cardboard close to the oven's final location. 4 A B A. Oven door hinge lock in locked position B. Oven door hinge lock in unlocked position