Jenn-Air JS42PPDUDB Dimension Guide - Page 1
Jenn-Air JS42PPDUDB Manual
View all Jenn-Air JS42PPDUDB manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1 highlights
Side by Side Built-In Refrigerator PRODUCT MODEL NUMBERS JS42CXDBD JS42CXDUD JS42PPDUD JS42SEDUD JS48CXDBD JS48CXDUD JS48PPDUD JS48SEDUD JS48SEDUE Electrical: A 115 Volt, 60 Hz., AC only 15- or 20-amp fused, grounded electrical supply is required. It is recommended that a separate circuit serving only your refrigerator be provided. Use an outlet that cannot be turned off by a switch. Do not use an extension cord. A grounded 3 prong electrical outlet should be placed within 4" (10.2 cm) of the right side cabinets or end panel. Water Supply: A cold water supply with water pressure between 30 and 120 psi (207 and 827 kPa) is required to operate the water dispenser and ice maker. If you have questions about your water pressure, call a licensed, qualified plumber. If a reverse osmosis water filtration system is connected to your cold water supply, the water pressure to the reverse osmosis system needs to be a minimum of 40 to 60 psi (276 to 414 kPa). The water shutoff should be located in the base cabinet on either side of the refrigerator or some other easily accessible area. If the water shutoff valve is not in the cabinets, the plumbing for the water line can come through the floor or the back wall. Location: Do not install the refrigerator near an oven, radiator, or other heat source, or in a location where the temperature will fall below 55°F (13°C). Floor must support the refrigerator weight, more that 600 lbs (272 kg), door panels and contents of the refrigerator. OPENING DIMENSIONS A solid soffit or wall cabinet must be installed 84" (213.4 cm) above the floor. If the solid soffit is higher than 84" (213.4 cm) or one is not available, then the refrigerator must be braced. For a fully integrated installation, a minimum of 6" (15.24 cm) of open space above the refrigerator is required. Anti-tip boards are required. If the anti-tip boards are needed, they must be attached to the rear wall studs so that there is 84" (213.4 cm) from the bottom of the anti-tip board to the floor. See "Install Anti-Tip Boards" for more information. 80" - 90" (203-229 cm) B Dimension 83¹⁄₂" (212.1 cm) min. 84³⁄₄" (215 cm) max. to bottom of solid soffit 77" (196 cm) Model Width A (as shown) Dimension B (as shown above) 42 41¹⁄₂" (105.4 cm) to 10" (25.4 cm) 41³⁄₄" (106.1 cm) 48 47¹⁄₂" (120.7 cm) to 16" (40.6 cm) 47³⁄₄" (121.3 cm) PRODUCT DIMENSIONS s The power cord is 84" (213 cm) long. s The line attached to the back of the refrigerator is 5 ft. (1.5 m) long. s Width dimensions were measured from trim edge to trim edge. s The depth from the front of the top grille to the back of the refrigerator cabinet is 25 3⁄8" (64.5 cm) for Euro and Pro-style®. The Overlay style depth is 251⁄8" (63.8 cm) without panels. s The required thickness for all custom overlay panels is 3⁄4" (1.91 cm). SIDE VIEW Euro-Style and Pro- Style® 25³⁄₈" (64.5 cm) ³⁄₈" (9.53 mm) Overlay Style 25¹⁄₈" (63.8 cm) *83³⁄₈" (211.8 cm) 84" (213.4 cm) Power Cord *83³⁄₈" (211.8 cm) 84" (213.4 cm) Power Cord *3¹⁄₂" (8.9 cm) *3¹⁄₂" (8.9 cm) *When leveling legs are fully extended to 1¹⁄₄" (3.2 cm) below rollers, add 1¹⁄₈" (2.9 cm) to the height dimensions. *When leveling legs are fully extended to 1¹⁄₄" (3.2 cm) below rollers, add 1¹⁄₈" (2.9 cm) to the height dimensions. TOP VIEW Euro-Style and Pro- Style® A 24¹⁄₈" (61.3 cm) 23 60.3 cm) 23¹⁄₂" (59.7 cm) A Width (see chart following) 6" (15.2 cm) Model 42 Euro-Style 48 Euro-Style 42 Pro- Style® 48 Pro- Style® B A 41" (104.1 cm) 47" (119.4 cm) 41" (104.1 cm) 47" (119.4 cm) B 2¹⁄₈" (5.3 cm) 2¹⁄₈" (5.3 cm) 2⁵/₈" (6.67 cm) 2⁵/₈" (6.67 cm) Overlay Style A 1" 6" (2.54 cm) (15.2 cm) 24" (60.96 cm) min. 6" (15.2 cm) 23 60.16 cm) IMPORTANT: s Flooring under refrigerator must be at same level as the room. Face of cabinetry must be plumb. s The width of the opening (Width A), must be as specified for your model, for at least 2" (5.08 cm) back from the face of the cabinet. If your opening does not meet this requirement, you will need to make modifications. Model 42 48 Width A 41" (104.1 cm) 47" (119.4 cm) Because Whirlpool Corporation policy includes a continuous commitment to improve Dimensions are for planning purposes only. For complete details, see Installation our products, we reserve the right to change materials and specifications without notice. Instructions packed with product. Specifications subject to change without notice. Ref. W10379134A 1/11/12