Jenn-Air JUBFR242HM Owners Manual 1 - Page 8

ELECTRICAL REQUIREMENTS WARNING Electrical Shock Hazard Plug into a grounded 3 prong outlet. Do not remove ground prong. Do not use an adapter. Do not use an extension cord. Failure to follow these instructions can result in death, fire, or electrical shock. Before you move your beverage center into its final location, it is important to make sure you have the proper electrical connection. RECOMMENDED GROUNDING METHOD A 115 V, 60 Hz, AC only, 15 or 20 A fused, grounded electrical supply is required. It is recommended that a separate circuit serving only your beverage center be provided. Use an outlet that cannot be turned off by a switch. Do not use an extension cord. NOTE: Before performing any type of installation, cleaning, or removing a light bulb, unplug beverage center or disconnect power. INSTALLATION INSTRUCTIONS UNPACK THE BEVERAGE CENTER WARNING Excessive Weight Hazard Use two or more people to move and install beverage center. Failure to do so can result in back or other injury.  Dispose of and/or recycle all packaging materials.  After all packaging materials have been removed, clean the inside of your beverage center. Refer the cleaning instructions in "Cleaning" section. NOTE: For standard stainless steel or glass door models, skip to "Door Closing" section. Before using your beverage center, all packaging materials should be removed and the interior should be cleaned.  Remove tape and glue residue from surfaces before turning on the beverage center. With your fingers, rub a small amount of liquid dish soap over any adhesive and wipe with warm water to remove.  Do not use sharp instruments, rubbing alcohol, flammable fluids, or abrasive cleaners to remove tape or glue. These can damage the surfaces of your beverage center. For more information, refer "Beverage center Safety" section. 8